Ask the Car People.SM


1996 Ford Ranger Starting Issue

5 messages,  Last post on Feb 25, 2013 at 1:46 PM

You are in the Ford Ranger Forum.

What is this discussion about? Ford Ranger, Truck

Messages Page 2 of 2

#2 of 5 95 ranger starting problems by kschencks

Dec 20, 2012 (8:49 am)

I have a 95 ford ranger and i started it up to drive to the store and when in got back in it to start it back up it cranked and ran briefly and cut off! I waited 2 min and it started up and i drove home. I have had a problem with a sqealing and i replaced the serpatien belt, but didnt stop the sqealing and now i have the starting issue. My question is, could this be a related issue?

#3 of 5 Re: 95 ranger starting problems [kschencks] by raldur

Dec 20, 2012 (12:16 pm)

Replying to: kschencks (Dec 20, 2012 8:49 am)
I am not sure. I wish I knew. I am newbie with fixing issues with my vehicle. I have been googl'ing nonstop for days. I replaced the battery because they could not charge it at advance auto parts. I am now suspecting the starter solenoid. It's a cheap thing to swap out. I just don't want to unload a lot more cash. I also read where the relay fuses may be gone. The thing I don't understand is why the truck can start in the morning, but after running around and parking for a while, it won't start up again. I hope it doesn't have anything to do with the transmission.

#4 of 5 Re: 95 ranger starting problems [raldur] by kschencks

Dec 22, 2012 (7:33 pm)

Replying to: raldur (Dec 20, 2012 12:16 pm)
lol. I know what you mean about not spending too much. I recently removed my fuel filter and it was clogged! I'm replacing it tomorrow and see how that works, but it makes sense to me though.

#5 of 5 96 Ranger that has been idle for 6 years by jules57

Feb 25, 2013 (1:46 pm)

We are looking to buy a 96 Ranger 4cyl. that has not been started for 6 years. We can smell old nasty gas but the tank is empty. We put in a few fresh gallons of gas but it wouldn't start. We can get the engine to start on ether but it won't pick up any fuel and run.. Should the injectors be the first place to start tearing out and checking for varnish? How can we tell if it is the fuel pump?

Messages Page 2 of 2

To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement