2001 Mazda Millenia will not start after over heat

Last post on Mar 09, 2012 at 2:38 PM

You are in the Mazda Millenia Forum.

What is this discussion about? Mazda Millenia, Sedan

  • All Messages Displayed

#1 of 1 2001 Mazda Millenia will not start after over heat by mrdj1001

Mar 09, 2012 (2:38 pm)

I replaced my radiator because it was leaking. I bought a used one and put it in along with a new thermostat. Everything was fine for about two days then the new to me radiator started leaking. I put some stop leak in it hoping this would help. It did not but it did slow the leak.
 
I was nursing the car home and watching to make sure I didn't over heat. As soon as it started raising up I pulled over. I think that the thermostat might not have been working because when I pulled over it was dry. As I was pulling off the road my car died. It did not jerk, make any excess noise, nothing.
 
I let it cool added more fluid and then tried to start it. It would not start. I have checked for spark (it is working), I have sprayed starter fluid into the carb to see if there is a fuel problem. I opened the oil cap and checked to make sure the cams were turning when I turned it over the timing belt is not broken. I did see a small amount of white smoke when I tried turning the engine over when I had over heated with it not starting.
 
I have not seen any milky color to the oil but I am assuming that I need to replace the head gaskets. My two questions are ...
 
Shouldn't the car still run with a blown head gasket? I know it will run rough but should still run ..
 
The other question I have is what else could make the car not start? It turns over but will not start
  • All Messages Displayed
To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement