Ask the Car People.SM


Replacing head gaskets - Pull engine or not?

2 messages,  Last post on Dec 13, 2011 at 3:49 PM

You are in the Subaru Legacy & Outback Forum.

What is this discussion about? Subaru Legacy, Subaru Outback, Sedan, Wagon

Messages Page 1 of 1

  • All Messages Displayed

#1 of 2 Replacing head gaskets - Pull engine or not? by machius

Dec 13, 2011 (1:51 pm)

So, I am finally about to get my head gaskets replaced.
 
From whatever I have heard/read, my impression was that the "proper" way of doing that job is with the engine out. However, the service advisor at my local Subaru dealer says the job gets done properly independent of wether the engine gets pulled or not. Only one of the six mechanics at that dealership actually pulls the engine for this kind of job.
 
My question is should I insist on having the engine pulled or not?
 
I need to go to a dealership, because it's a warranty issue that SoA is partially helping me out here with.
 
Thanks!
MM

#2 of 2 Re: Replacing head gaskets - Pull engine or not? [machius] by xwesx

Dec 13, 2011 (3:49 pm)

Replying to: machius (Dec 13, 2011 1:51 pm)
No, it doesn't have to be pulled, but it is a heck of a lot easier that way! I would expect the job done right regardless of their method, so if you get it back and it continues to leak, it's on the shop to get it right.

Messages Page 1 of 1

  • All Messages Displayed
To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement