You have saved this page | See all saved pages
vehicle jerking, stalled/Mercury villager 99
7 messages, Last post on Dec 09, 2011 at 3:08 PM
You are in the Nissan Quest Forum.- Your Host is kcram
What is this discussion about? Nissan Quest, Van
- « Previous
- 1
- 2
- Next »
- Last
#5 of 7 sensors by plui
Dec 03, 2011 (10:47 am)
I found that the screen of scanner showed 4 sensors, P325 & P1336, and other two showed the same sensors/arrow up & down after the engine light came on.The problem showed the same when the vehicle started at beginning fine, but the idle became rough and stalled after I kept running more than 5 miles. I tried to put injetor cleaner, gas treatment, and the other one which the bottle is yellow, into gas tank everytime when I filled the gas tank
more than half.
May I have someone give me some idea?
Best Regards,
Peter
- dtownfb (Dec 09, 2011 3:08 pm)
Replies to this message:
#6 of 7 Re: sensors [plui] by dtownfb
Dec 09, 2011 (3:08 pm)
Replying to: plui (Dec 03, 2011 10:47 am)
P0325 is a knock sensor code. If I remember right, this has to do with the distributor cap. It's a common failure on this vehicle. P1336 - pertains to the crankshaft position sensor not operating properly. From what I have read, this may able as simple as replacing the CKP or could indicate an issue with the ECU.
Hopefully someone can give you more information on the P1336
- « Previous
- 1
- 2
- Next »
- Last
To POST a message, please
Sign In.
Advertisement
Most Popular in Forums
Search Forums
Enter Keyword(s):
Learn More, Do More
Edmunds Community
Advertisement