Ask the Car People.SM


vehicle jerking, stalled/Mercury villager 99

7 messages,  Last post on Dec 09, 2011 at 3:08 PM

You are in the Nissan Quest Forum.

What is this discussion about? Nissan Quest, Van

Messages Page 2 of 2

#3 of 7 idle slow, die and engine came on by plui

Oct 16, 2011 (12:22 am)

Thank you for someone's reply to my previous question this morning.
My another question is what is happened if distributor failures. My vehicle Mercury villager 98 or 99 became jerking, idle was slow, engine light came on and die after I ran it 5 or 6 miles. Fortunately, I could crank over again and kept it running in 20 mile mph to a safer place.
I am appreciated if any one could give me some advice.
 
Peter L

#4 of 7 Re: idle slow, die and engine came on [plui] by mchellman

Oct 19, 2011 (9:21 am)

Replying to: plui (Oct 16, 2011 12:22 am)
As a previous poster said, go to autozone or other parts store and have them read the faults. Autozone will give you a printed output so there will be no confusion. You can report that here and see if anyone can diagnose your problem.
 
I think that there are many, many possible causes. The fuel filter was a reasonable guess, but just a guess nonetheless.

#5 of 7 sensors by plui

Dec 03, 2011 (10:47 am)

I found that the screen of scanner showed 4 sensors, P325 & P1336, and other two showed the same sensors/arrow up & down after the engine light came on.
 
The problem showed the same when the vehicle started at beginning fine, but the idle became rough and stalled after I kept running more than 5 miles. I tried to put injetor cleaner, gas treatment, and the other one which the bottle is yellow, into gas tank everytime when I filled the gas tank
more than half.
 
May I have someone give me some idea?
 
Best Regards,
 
Peter

#6 of 7 Re: sensors [plui] by dtownfb

Dec 09, 2011 (3:08 pm)

Replying to: plui (Dec 03, 2011 10:47 am)
P0325 is a knock sensor code. If I remember right, this has to do with the distributor cap. It's a common failure on this vehicle.
 
P1336 - pertains to the crankshaft position sensor not operating properly. From what I have read, this may able as simple as replacing the CKP or could indicate an issue with the ECU.
 
Hopefully someone can give you more information on the P1336

Messages Page 2 of 2

To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement