Ask the Car People.SM


Occasional trouble starting

8 messages,  Last post on Dec 06, 2010 at 2:09 PM

You are in the Subaru Legacy & Outback Forum.

What is this discussion about? Subaru Legacy, Subaru Outback, Sedan, Wagon

Messages Page 2 of 2

#6 of 8 RE: xwesx [mattcarter] by xwesx

Dec 06, 2010 (11:29 am)

Replying to: mattcarter (Dec 06, 2010 8:18 am)
That's certainly possible. I would have to run through my records on that car to see which codes had actually set. Since I replaced all three at the same time, I cannot say for sure which resolved the no-start, but I certainly never had any codes pop up when the no-start was the only problem (unfortunately!).
 
The Camshaft Position sensor is the easiest of the three to access and should take only a few minutes to replace. It is located on the driver side, front of the engine... at the top front corner just to the left (if you're looking at the engine) of the oil filler spout and, I think, to the right of the air conditioning compressor. If memory serves, you should be able to get to it without removing anything else!

#7 of 8 RE: xwesx [xwesx] by mattcarter

Dec 06, 2010 (12:24 pm)

Replying to: xwesx (Dec 06, 2010 11:29 am)
That is awesome. I will try that and let you know. Thanks for the feedback!

#8 of 8 RE: xwesx [mattcarter] by xwesx

Dec 06, 2010 (2:09 pm)

Replying to: mattcarter (Dec 06, 2010 12:24 pm)
Here is an annotated photo of my engine back in 2005. If you have the SOHC, which I think was the case in 1998, it is going to look a little different, but I think the sensors were in the same general location.
 

 
Of course, this is only available for the next three days....

Messages Page 2 of 2

To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement