Last post on Dec 29, 2010 at 10:39 AM
You are in the Toyota Highlander
What is this discussion about?
Toyota Highlander, SUV
#17 of 21 Mint oil didn't work for us
Dec 23, 2010 (10:20 am)
I ordered the mint oil from Amazon. In the interim, I left the hood open each night. No mouse nests. The oil came in day before yesterday. I sprayed the engine, what is left of the firewall insulation, and all around the engine compartment. I left the hood closed last night.
This morning... another mouse nest. Dang.
I'm gonna look for mothballs today. I'd already tried dryer softener sheets, which also didn't work. (These "remedies" from an RV forum)
And I still haven't had a chance to put the car up on ramps to check underneath. I live in CA and my ramps are outside. What a couple of weeks for rain!!
#18 of 21 Re: Hill assist/VSC lights on in dashboard [wwest]
Dec 23, 2010 (1:30 pm)
I got the code for the CE light and then narrowed it to a electric wiring fault on the engine..forgot the connection name..but as soon as I removed the engine cover saw that the electric wiring might have been cut off by a rat or something. Got the wiring soldered and now it works fine and the warning light on the dash board for hill assist and VSN has gone away after I reset the battery connection. Thanks.
#19 of 21 Re: Mint oil didn't work for us [phrosut]
by Stever@Edmunds HOST
Dec 23, 2010 (2:47 pm)
That's a bummer.
I was up at Kings Canyon a few years ago and there must be a varmint problem up there. People would put chicken wire fencing around their cars or they'd put a big tarp on the ground and the drive onto the tarp. Then they'd take the corners of the tarp and pull it up to the roof and tie it off. Sure looked weird, but better than ruined wiring.
I guess you'll have a lifetime supply of mint to doctor your hot tea with now.
#20 of 21 rats and wires
Dec 23, 2010 (4:03 pm)
I was hoping to a solution like post #18 by dallas12 and just have some wires to repair. I can't find ANY evidence of nibbling anywhere visible from the top. Maybe tomorrow I can get it up on ramps and check underneath. I'll also unplug/replug any connectors I can.
Steve, that suggestion was cheap enough... it says it can be used to prevent head lice too and we have a relative that'll be starting school next year...
So far the only surefire prevention is to leave the hood open at night, which is what I do with the other vehicles that aren't driven daily. It's just a PIA on a daily driver.
#21 of 21 Re: rats and wires [phrosut]
Dec 29, 2010 (10:39 am)
1) since the "upgrade" of this site, when I try and correct spelling or grammar on a post, I lose most of the post and get the '4- arrows' thing like I'm editing a JPG. I've usually given up after a couple of tries, and now will just make the post without corrections.
2) looking for mothballs, I found something resembling a urinal cake in a plastic container for moths. I hung it in the engine compartment. Before putting that in, IF I closed the hood overnight, there'd be a complete nest with an ample store of acorns the next morning.
After hanging it in under the hood, and closing the hood overnight, there'd be one 'mouthful' of nesting material and acorns.... like it got there with a full load then decided to leave because of the smell. HOWEVER, that moth thing is almost disolved after only 5 days so that's not gonna work. So I'm leaving the hood open at night and there is no evidence of nesting.
Back to the VSC light: I found a spot on the little hose from the air cleaner housing that causes the error after changing filters that had a little chew hole. Fixed it, disconnected the battery to reset, then the light was off. For 20 miles. Now back on. I'd put more details here but...
1) this new forum software would prevent it and
2) I don't have a solution or answer yet so who cares?