You have saved this page | See all saved pages
Hitch receiver and wiring
7 messages, Last post on Sep 23, 2010 at 1:53 PM
You are in the Mazda Mazda5 Forum.- Your Host is kcram
What is this discussion about? Mazda MAZDA5, Van
- « Previous
- 1
- 2
- Next »
- Last
#5 of 7 Re: Hitch receiver and wiring [qbrozen] by reticulum12
Sep 15, 2010 (11:21 am)
Replying to: qbrozen (Sep 15, 2010 11:13 am)
There are 2 different model for the mazda 5: http://www.etrailer.com/hitch-2010_Mazda_5.htm
I took the model 11338. I bought it on e-bay. I have installed it last WE and it fit perfectly. I takes a lot of effort to enlarge the 2 existing holes in the bumper but this is the only difficulty. I should have bought the wiring harness at the same time it would have been less expensive.
- qbrozen (Sep 15, 2010 6:17 pm)
Replies to this message:
#6 of 7 Re: Hitch receiver and wiring [reticulum12] by qbrozen
Sep 15, 2010 (6:17 pm)
Replying to: reticulum12 (Sep 15, 2010 11:21 am)
Ok. Thanks. That's the same place I was looking. Couldn't see why I wouldn't just go with the cheapest, though.
- reticulum12 (Sep 23, 2010 1:53 pm)
Replies to this message:
#7 of 7 Re: Hitch receiver and wiring [qbrozen] by reticulum12
Sep 23, 2010 (1:53 pm)
Replying to: qbrozen (Sep 15, 2010 6:17 pm)
I have installed the wiring harness last week end. Everything is working perfectly fine. I did not run a wire up to the battery but instead I used the 12 Volt from the trunk.
- « Previous
- 1
- 2
- Next »
- Last
To POST a message, please
Sign In.
Advertisement
Most Popular in Forums
Search Forums
Enter Keyword(s):
Learn More, Do More
Edmunds Community
Advertisement