Last post on Oct 05, 2010 at 6:48 PM
You are in the Subaru Legacy & Outback
What is this discussion about?
Subaru Legacy, Subaru Outback, Engine, Fuel System, Steering, Suspension, Sedan, Wagon
#11 of 16 Re: 2001 Legacy/Outback Shaking at Highway Speeds: Help! [fibber2]
Sep 26, 2010 (6:04 am)
This is a manual shift car. It happens when I am at steady, highway speeds. I am usually going about 75 mph when it starts, but slowing down does not make it stop faster. And it isn't really a "sudden" thing. It starts gradually and goes away gradually on its own. On my way to work, I transfer highways, so that I am going about 70-75 on the first highway, slow down to about 50, then speed back up to 70-75. On may way to work, if it does this, then it usually happens after I speed back up on the second highway, so I have wondered if that sets it off, but it has also done it to me at other random times in other random places, but always at highway speeds.
I actually do have an appointment for it in about a week for someone to look at it.
#12 of 16 Re: 2001 Legacy/Outback Shaking at Highway Speeds: Help! [fibber2]
Sep 27, 2010 (1:29 pm)
I took your advice and put the clutch in when it was vibrating, and it did not have much of an effect. I'm not sure how many of these posts you read, but it was doing this to me before my drive shaft was replaced. Although, I was thinking that it must not have been doing it when I had my head gaskets done, otherwise I would have mentioned it to the mechanics that did those. Is it possible that when that was done, that there could have been a mistake or could something have gotten overlooked that would cause this?
#13 of 16 Re: 2001 Legacy/Outback Shaking at Highway Speeds: Help! [booba2]
Sep 28, 2010 (5:34 am)
Boy, now you have me scratching my head!
I didn't see this as a shaft balance issue as it doesn't happen consistently at around the same speed and conditions. A permanently out of balance component (tire with a broken belt, bent rim, shaft missing a weight) usually gives a pretty repeatable performance. If it is occuring and you depress the clutch, one would expect the shake to continue. But again, you should be able to induce it easily by just hitting the right speed.
If it was an engine misfire (injector problem, ignition failure), you would expect to eventually get a CEL. I know that even with an automatic, it is possible to load the engine down on a hill and make it 'lug' a bit prior to getting a downshift. That produces a bit of shake, but it disappears as soon as the downshift occurs. It is a form of misfire, but not enough to throw a code. But depressing the clutch at speed would make that instantly go away as the load drops and the RPM drops.
One thought. Yours is an '01. Mine car was a very early '02 that came thru with '01 brakes. I hate the brakes on this car. They are very prone to 'warpage' (actually an uneven material transfer to the disk that results in thickness variation). I can scrub this off and smooth out the braking, but under some conditions it comes back. On some long, high speed drives I've had 'transfer' occur for unknown reasons. Minor contact friction building up heat??? Net is that sometimes when I do get on the brakes, the front end shakes, and I can sometimes feel it even when not touching the pedal. Slow down or stop for a while, and it goes away. Inspection doesn't indicate a non-retracting caliper, and brake wear appears to be quite normal. I've got around 35k on this set of pads, and they still look OK. But it does sound a little like what you describe.
You might want to have your mechanic do a thorough check of the calipers (sliders and piston retraction), look for uneven wear, etc.
Long shot, but without driving it, it is hard to diagnose.
#14 of 16 Re: 2001 Legacy/Outback Shaking at Highway Speeds: Help! [booba2]
Sep 30, 2010 (11:00 am)
With my 01 OB wagon (automatic) air pressure differences in the front tires can increase vibration very similar to a tire or two out of balance. Simple enough to check.
#15 of 16 Re: 2001 Legacy/Outback Shaking at Highway Speeds: Help! [jd_24]
Sep 30, 2010 (4:05 pm)
You have to be careful about that one. Enough of a pressure difference on the front two can result in the front differential speed averaging below the rear. This can overheat the center diffy wet clutch and burn the ATF.
#16 of 16 Re: 2001 Legacy/Outback Shaking at Highway Speeds: Help! [fibber2]
Oct 05, 2010 (6:48 pm)
Agree! I found that I had about about 4 psi difference in the two front tires. (I got lazy in checking) A very minor out-of-balance issue felt way more pronounced. The two rear were OK and at spec. One front tire wass at spec.