Last post on Apr 20, 2012 at 4:11 AM
You are in the Honda Insight
What is this discussion about?
Honda Insight, Hybrid Cars, Engine, Hatchback
#31 of 35 Re: Oil pan replacement [gagrice]
Nov 27, 2008 (9:11 pm)
FYI, the pan is Magnesium and is extremely expensive to replace. If the threads are stripped, have a helicoil inserted to fix it.
#32 of 35 Re: Oil pan replacement [Ogre_GEV]
Dec 05, 2009 (9:21 pm)
I have 2000 Insight, and have taken it to the same Dealer for the past 3 years that I have had the car. Last time I had the oil changed they told me that next time I'd have to replace the oil pan since the threads weren't holding. I asked to see the service manager and explained that this was the only place that had changed the oil in 3 years, that the specs to tighten the nut were made so that the threads would not be stripped, that if the techs were following the specs then everything should be fine and as an added safety measure Honda specifies a crush washer. He went out and talked with the tech who had done the work, came back in and said that the next time I changed my oil, they would change out the oil pan at their expense....
#33 of 35 Re: Oil pan replacement [rushd]
Mar 27, 2010 (3:30 pm)
Well they replaced it! I called to make an apointment for an oil change, reminded them that the service manager would replace the pan for free and they said no problem, bring it in 2 days from now. I did, they changed it out, I thanked them and the service manager said aren't you the one that had a bad bat pack? I told him how it was refurbished and he said good for you.
#35 of 35 Re: Oil pan replacement [runnersfoot]
Apr 20, 2012 (4:11 am)
The mechanics are in a hurry and typically tighten the steel bolt into the aluminum threaded pan with to much torque srreatching the threads. A Heliocoil is your best bet. Always replace with a new aluminum washer or it will leak, trust me on this. As for now, use Teflon pipe tape around the bolt at least two turns to fill up the gap and protect from leaks, it also prevents wear on the treads. To bad you didn't use Teflon tape from the beginning!