2006 Jeep CRD Battery goes dead

7 messages, Last post on Apr 10, 2009 at 9:58 AM

You are in the Jeep Liberty and Jeep Liberty Diesel Forum. Your Hosts are steve_ & tidester

What is this discussion about? Jeep Liberty, Diesel, SUV

Outline

Messages Page 2 of 2: 1; 2; Prev; Next; Last

#6 of 7 Re: will check that out [buckmc] by sthoge Apr 09, 2009 (11:11 am)
Replying to: buckmc (Apr 08, 2009 2:43 pm) I'm not really sure where it was connected at, just that they were connected to the wrong location. I wasn't the one to pick up the vehicle so I could have them show me. Replies to this message: caribou1 (Apr 10, 2009 9:58 am)
#7 of 7 Re: will check that out [sthoge] by caribou1 Apr 10, 2009 (9:58 am)
Replying to: sthoge (Apr 09, 2009 11:11 am) On my truck there is a dedicated 'leg' of the wiring harness hidden behind the left side panel, inside the trunk. This is where the trailer lights should be connected when using the official equipment. There should be a set of solid state relays to provide connection instead of ordinary 'Faston' connections.

#6 of 7: Re: will check that out [buckmc] by sthoge; Apr 09, 2009 (11:11 am)

Replying to: buckmc (Apr 08, 2009 2:43 pm)

I'm not really sure where it was connected at, just that they were connected to the wrong location. I wasn't the one to pick up the vehicle so I could have them show me.

caribou1 (Apr 10, 2009 9:58 am)

#7 of 7: Re: will check that out [sthoge] by caribou1; Apr 10, 2009 (9:58 am)

Replying to: sthoge (Apr 09, 2009 11:11 am)

On my truck there is a dedicated 'leg' of the wiring harness hidden behind the left side panel, inside the trunk. This is where the trailer lights should be connected when using the official equipment. There should be a set of solid state relays to provide connection instead of ordinary 'Faston' connections.