Sign In Join 



2001 Chrysler T&C Front End Noise

7 messages,  Last post on Mar 31, 2009 at 6:34 PM

You are in the Chrysler Town & Country/Dodge Grand Caravan Forum. Your Host is Karens

What is this discussion about? Chrysler Town and Country, Wheels, Van


Messages Page 1 of 1
All Messages Displayed
Go To Msg #
Search This Discussion

#1 of 7
2001 Chrysler T&C Front End Noise by sbradshaw
Mar 24, 2009 (5:01 am)
Reply
I have a 2001 Caravan and T&C and both make clanking noise. The struts,ball joint, & bearing were replaced on the T&C and tie rods inspected and still don't know where the noise is coming from. Mechanic sd he had one already in shop making the same noise. Dodge is in shop now have rack replaced. Someone said that should fix the noise in it too. The T&C only makes the clanking noise on the passenger side. It's driving me nuts and I'm afraid it's dangerous. Mechanic just gave up.
#2 of 7
Re: 2001 Chrysler T&C Front End Noise [sbradshaw] by masterpaul1
Mar 24, 2009 (5:56 pm)
Reply

Replying to: sbradshaw (Mar 24, 2009 5:01 am)

Have them to replace the links and bushings. These are a common problem for these vechicles. We've had our replaced twice in six years.
#3 of 7
Re: 2001 Chrysler T&C Front End Noise [sbradshaw] by tabrox
Mar 30, 2009 (7:24 pm)
Reply

Replying to: sbradshaw (Mar 24, 2009 5:01 am)

I too have replaced the... 'it must be this'... part including the struts, sway bar links and bushings. Nothing has rid the dreaded Klunk! It would be greatly appreciated if you would post the results of the rack repair. Good Luck!
#4 of 7
Re: 2001 Chrysler T&C Front End Noise [tabrox] by sbradshaw
Mar 31, 2009 (4:49 am)
Reply

Replying to: tabrox (Mar 30, 2009 7:24 pm)

I have a 2001 Dodge Grand Caravan too. It was making a bad clunking noise, almost the same but not as loud. The steering went out and it was diagnosed the rack and pinion. After it was replaced, the noise is not noticed as much now. I think if I replace the links in it there will be no noise at all. This leads me to believe it is the rack in the Chrysler. It was suggested to be the cv shaft but it does not make a popping noise when I back up or turn sharply. I have had a cv joint to go bad on another Dodge and it was a totally different noise. This noise is only heard when you go over a bump in the road.
#5 of 7
How do you remove the cover on the heater blower motor? by sbradshaw
Mar 31, 2009 (4:54 am)
Reply
I tried to replace the heater blower motor but there is something in the back holding it. The internet diagram only shows 3 bolts and I have removed them already. There is no way to get back there to see. Its uner the dash on the passenger side. I don't want to damage the moveable parts attached to the cover. Does the dash have to come out?
#6 of 7
Re: 2001 Chrysler T&C Front End Noise [sbradshaw] by jaag
Mar 31, 2009 (10:42 am)
Reply

Replying to: sbradshaw (Mar 24, 2009 5:01 am)

I replaced the front sway bar rubber bushings from napa and the noise went away on my 2002 Chrysler T&C. I hope this helps.
#7 of 7
Re: How do you remove the cover on the heater blower motor? [sbradshaw] by sbradshaw
Mar 31, 2009 (6:34 pm)
Reply

Replying to: sbradshaw (Mar 31, 2009 4:54 am)

just to let anyone interested to know....I never found a screw in the back holding hthe cover on. Apparently it was glued stuck but eventually cracked the plastic in the back. It looked like it was sealed when I removed it I could see the problem. There is a door panel that is rotated by a small motor on the bottom of the cover. That panel does not come off with the cover. It's a nuckle busting job you have to do standing on your head.

Messages Page 1 of 1
All Messages Displayed
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement