You are here:
Forums
SUVs
Kia Sportage
Rebuilding My Kia Sportage Engine

6 messages, Last post on Mar 15, 2009 at 12:45 PM
You are in the Kia Sportage Forum. Your Hosts are steve_ & tidester
|
|
Hello, I am rebuilding a 2000 Kia Sportage engine. I know,,,hooray. At any rate, I had taken the block in to be boiled and the head to be resurfaced, valve seals, etc. any way when I picked up my stuff when it was done, they had to remove a bolt or two to be cleaned properly and put them neatly in a plastic bag, but also there was a very small hard rubber bushing in with it. I have know idea where it goes and the machine shop dont know either..So is this machine shop taking me snipe hunting or does this little bushing actually goes some where, Its about a 1/4" wide and about the same as high. I do have a pic of it, but,,how to post
|
|
|
Replying to: rkeeling (Mar 06, 2009 8:26 pm) tidester, host SUVs and Smart Shopper
|
|
|
Replying to: tidester (Mar 06, 2009 9:23 pm)
|
|
|
Replying to: rkeeling (Mar 10, 2009 7:50 pm) and the picture: See more Car Pictures at CarSpace.com I hope that helps. tidester, host SUVs and Smart Shopper |
|
Yes,,you are a saint,,,now we might be able to find out what this item is if some one happens to see it,, again thanks a million
|
|
|
Replying to: rkeeling (Mar 11, 2009 5:05 pm) screams suspension. doubt its a bump stop then again i wouldnt know i never had them to begin with. i dont know of anything on the engine that would be like that. where did you find it and can u guess where abouts it fell off the kia? give size next to a machinist rule and differnet views. if it is small enough could it be a head valve oil seal ? My comment: take another photo with a ruler beside. |
|
|
You are here:
Forums
SUVs
Kia Sportage
Rebuilding My Kia Sportage Engine
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2009 Kia Sportage



Browse by Board
Browse by Topic
Today's Chats