Ask the Car People.SM


Wheels stuck on hub

3 messages,  Last post on Apr 13, 2009 at 6:05 PM

You are in the Toyota 4Runner Forum.

What is this discussion about? Toyota 4Runner, Wheels, SUV

Messages Page 1 of 1

  • All Messages Displayed

#1 of 3 Wheels stuck on hub by brazell

Mar 06, 2009 (2:31 pm)

I have a 94 4Runner and both front wheels are stuck on the hubs. I've tried driving it with the lug nuts loose and even that hasn't broken them free.
 
I've sprayed w-D40 and I've beat on the inside of the tires with a sledge. Anyone have any other suggestions or tips?

#2 of 3 Re: Wheels stuck on hub [brazell] by goodstar

Mar 06, 2009 (6:28 pm)

Replying to: brazell (Mar 06, 2009 2:31 pm)
After you have raised the vehicle and removed the lug nuts if you sit on the ground beside the wheel and kick them with the bottom of your foot it should break them loose. Kick toward the front of the wheel then the back, alternating it should break them loose. it works better than the sledge hammer. Spray the wd40 generously around the wheel where the lug bolts come through the wheel will help.

#3 of 3 Re: Wheels stuck on hub [goodstar] by atarifan49

Apr 13, 2009 (6:05 pm)

Replying to: goodstar (Mar 06, 2009 6:28 pm)
As Goodstar has recommend, I'll expand on that. I had a 1986 Toyota Pickup 2WD that had the rear hubs cold-welded on by rust. When I was stationed at Beale AFB I had a neighbor who worked in the motor pool and had to contend with large diesel vehicles that had this problem a lot. He recommended to do the following:
1) get several cans of WD-40 (1 for each wheel and an extra one).
2) Spray the entire can in the area where it's stuck and let sit over night.
3) next day using a rubber mallet and your hands and attempt to break the coldweld. Do this by applying outward pressure on the left side and whack the right side with the mallet.
4) turn the wheel and repeat 3 until it breaks loose.
5) Once removed apply a coating of anti-seize compound to prevent the two surfaces from doing that again.
 
In the case of a wheel stuck to a hub do the same steps above but instead use Goodstar recommendation of kicking one side of the wheel while another person pulls out on the other side. Make sure the vehicle is securely and firmly sitting on jack stands for safety.
 
Good luck!

Messages Page 1 of 1

  • All Messages Displayed
To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement