Toyota Sienna Deactivating Laser Cruise Control

8 messages, Last post on Mar 08, 2009 at 9:49 PM

You are in the Toyota Sienna Forum. Your Host is Karens

What is this discussion about? Toyota Sienna, Electrical, Engine, Van

#6 of 8 by ploobers Feb 27, 2009 (12:05 am)
Nope. I tried holding it down for up to 10 seconds and it didn't make any difference.
#7 of 8 by ploobers Mar 08, 2009 (9:49 pm)
I finally figured it out. When I go to turn on the cruise control while I'm driving, it tries to communicate with the laser and throws the whole cruise control into lockdown. If I turn it on while I'm stopped, or even while I'm going really slowly, and then change it to normal mode like has been suggested, I can use it just fine. It's not a perfect solution, but not a bad one. It just means that half the time when I get on the freeway, I have to pull over and stop so that I can activate the cruise control before starting again. Thanks for all of your help and suggestions!