Sign In Join 



Toyota Sienna Deactivating Laser Cruise Control

8 messages,  Last post on Mar 08, 2009 at 9:49 PM

You are in the Toyota Sienna Forum. Your Host is Karens

What is this discussion about? Toyota Sienna, Electrical, Engine, Van


Messages Page 2 of 2
1
2
Prev
Next
Last
Go To Msg #
Search This Discussion

#2 of 8
Re: Deactivating Laser Cruise Control [ploobers] by g3guy
Feb 25, 2009 (8:33 pm)
Reply

Replying to: ploobers (Feb 25, 2009 4:14 pm)

The thing has to be on a fuse somewhere. Get the dealer or someone from a good auto parts store to look at your owner's manual to find it and pull it, then see what you have lost. If you're lucky, you'll only lose the laser; if not there may be some other things that are also deactivated, but you can decide if you can live without them. Good luck....
#3 of 8
Re: Deactivating Laser Cruise Control [ploobers] by hause7
Feb 25, 2009 (11:27 pm)
Reply

Replying to: ploobers (Feb 25, 2009 4:14 pm)

We had an 04 Sienna with the laser cruise and if I remember correctly if you pull the stalk towards you for a few seconds(it says mode on the stalk) it alternate between normal and laser cruise. You can use either one, you don't have to use laser cruise.
#4 of 8
by ploobers
Feb 26, 2009 (9:11 am)
Reply
g3guy - I found a schematic online of the electronics. Would you know which fuse I should pull, or which other features might be deactivated?
http://econtent.autozone.com:24991/znetrgs/repair_guide_content/en_us/images//09- 00c152/80/19/7c/5f//large/0900c15280197c5f.gif
#5 of 8
by ploobers
Feb 26, 2009 (9:12 am)
Reply
hause7 - I tried that and it doesn't seem to work. Maybe I wasn't holding it long enough, so I'll try again.
#6 of 8
by ploobers
Feb 27, 2009 (12:05 am)
Reply
Nope. I tried holding it down for up to 10 seconds and it didn't make any difference.
#7 of 8
by ploobers
Mar 08, 2009 (9:49 pm)
Reply
I finally figured it out. When I go to turn on the cruise control while I'm driving, it tries to communicate with the laser and throws the whole cruise control into lockdown. If I turn it on while I'm stopped, or even while I'm going really slowly, and then change it to normal mode like has been suggested, I can use it just fine. It's not a perfect solution, but not a bad one. It just means that half the time when I get on the freeway, I have to pull over and stop so that I can activate the cruise control before starting again.
 
Thanks for all of your help and suggestions!

Messages Page 2 of 2
1
2
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement