You are here: Forums SUVs GMC Yukon 2004 GMC Yukon XL Denali Traction Control

2004 GMC Yukon XL Denali Traction Control

15 messages,  Last post on Dec 01, 2009 at 8:53 PM

You are in the GMC Yukon Forum. Your Hosts are steve_ & tidester

What is this discussion about? GMC Yukon Denali, SUV

Messages Page 2 of 2 1 2 Prev Next Last

Go To Msg # Search This Discussion

#8 of 15 Re: traction control [isi] by jdlsierra May 27, 2009 (11:36 am)
Replying to: isi (May 27, 2009 11:15 am) you can remove the sensors by first removing your front brake caliper and then removing your rotor, the sensor is attached to the hub with a single allen bolt. I installed the new ones with " loctite " to be sure they stayed in place. This is the setup on my 2004 yukon denali.          I got to cut grass now so i will check back in 1 to 2 hours. Replies to this message: isi (May 27, 2009 11:54 am) isi (Jun 26, 2009 9:42 am) isi (Nov 30, 2009 3:53 pm)
#9 of 15 Re: traction control [jdlsierra] by isi May 27, 2009 (11:54 am)
Replying to: jdlsierra (May 27, 2009 11:36 am) Thanks again for the advice. I will tackle the job in a few days. Right now my son is occupying our hoist.
#10 of 15 Re: traction control [jdlsierra] by isi Jun 26, 2009 (9:42 am)
Replying to: jdlsierra (May 27, 2009 11:36 am) Replaced the front left sensor. Reused the front right as it looked really good. Still have the problem with traction control active. Will try replacing the front right sensor. Replies to this message: isi (Nov 30, 2009 3:53 pm)
#11 of 15 2004 Yukon Denali by boxman4 Nov 30, 2009 (3:17 pm)
Hi everyone, I have an engine light that goes on and off all the time. I tried new high grade fuel, the gas cap is tight and snapped when doing so but still the light goes on and off. I did notice that sometimes when I turned on the high beams the engine light would come on. It usually goes off in a day or two. Is it the battery or alternator?? Thanks, London, Ontario Replies to this message: isi (Nov 30, 2009 3:49 pm) boxman4 (Dec 01, 2009 8:53 pm) tidester (Nov 30, 2009 4:57 pm)
#12 of 15 Re: 2004 Yukon Denali [boxman4] by isi Nov 30, 2009 (3:49 pm)
Replying to: boxman4 (Nov 30, 2009 3:17 pm) The "Check Engine" light is usually related to emissions devices. For example it could be an O2 sensor, gas cap, MAF (mass airflow sensor) or a number of other emissions related problems. If you know someone with a code reader, check the error code, it will point you in the right direction. On my Denali, the gas cap was tight but the light still kept coming on intermittently. It turns out that there was a tiny crack in the rubber ring on the gas cap that forms the seal between the gas cap and the filler neck. A new gas cap solved the problem. Good luck. Replies to this message: boxman4 (Dec 01, 2009 8:53 pm)
#13 of 15 Re: traction control [isi] by isi Nov 30, 2009 (3:53 pm)
Replying to: isi (Jun 26, 2009 9:42 am) After replacing both front wheel speed sensors and scoping all 4 sensors, the problem still persists. It is likely a fault in the stability control module, which is epensive to replace and which must be coded to the vehicle by the dealer. So I will not go that route. I simply disable stability control and problem solved.
#14 of 15 Re: 2004 Yukon Denali [boxman4] by tidester HOST Nov 30, 2009 (4:57 pm)
Replying to: boxman4 (Nov 30, 2009 3:17 pm) You may want to try GMC Yukon Small Problems and Aggravations. We'll stick with "traction control" here.   tidester, host SUVs and Smart Shopper
#15 of 15 Re: 2004 Yukon Denali [isi] by boxman4 Dec 01, 2009 (8:53 pm)
Replying to: isi (Nov 30, 2009 3:49 pm) Thanks! I will try your suggestion.

Messages Page 2 of 2 1 2 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums SUVs GMC Yukon 2004 GMC Yukon XL Denali Traction Control