2004 GMC Yukon XL Denali Traction Control

10 messages, Last post on Jun 26, 2009 at 9:42 AM

You are in the GMC Yukon Forum. Your Hosts are steve_ & tidester

What is this discussion about? GMC Yukon Denali, SUV

#7 of 10 Re: traction control [jdlsierra] by isi May 27, 2009 (11:15 am)
Replying to: jdlsierra (May 27, 2009 10:57 am) Thanks for the advice. When you removed the sensors, did you first remove the hub and the half shaft, or do the sensors come out without having to take apart the hub? Replies to this message: jdlsierra (May 27, 2009 11:36 am) isi (May 27, 2009 11:54 am) isi (Jun 26, 2009 9:42 am)
#8 of 10 Re: traction control [isi] by jdlsierra May 27, 2009 (11:36 am)
Replying to: isi (May 27, 2009 11:15 am) you can remove the sensors by first removing your front brake caliper and then removing your rotor, the sensor is attached to the hub with a single allen bolt. I installed the new ones with " loctite " to be sure they stayed in place. This is the setup on my 2004 yukon denali. I got to cut grass now so i will check back in 1 to 2 hours. Replies to this message: isi (May 27, 2009 11:54 am) isi (Jun 26, 2009 9:42 am)
#9 of 10 Re: traction control [jdlsierra] by isi May 27, 2009 (11:54 am)
Replying to: jdlsierra (May 27, 2009 11:36 am) Thanks again for the advice. I will tackle the job in a few days. Right now my son is occupying our hoist.
#10 of 10 Re: traction control [jdlsierra] by isi Jun 26, 2009 (9:42 am)
Replying to: jdlsierra (May 27, 2009 11:36 am) Replaced the front left sensor. Reused the front right as it looked really good. Still have the problem with traction control active. Will try replacing the front right sensor.