You are here: Forums Sedans Saturn ION Power Window Motor

Power Window Motor

2 messages,  Last post on Mar 30, 2009 at 10:26 AM

You are in the Saturn ION Forum. Your Hosts are pat & karens

What is this discussion about? Saturn ION, Electrical, Coupe

Messages Page 1 of 1 All Messages Displayed

Go To Msg # Search This Discussion

#1 of 2 Power Window Motor by mjkiefer Jan 22, 2009 (3:54 pm)
Any one out there have a step by step resource for removing and installing a power window motor on a 2006 Ion? Replies to this message: shadowman2 (Mar 30, 2009 10:26 am)
#2 of 2 Re: Power Window Motor [mjkiefer] by shadowman2 Mar 30, 2009 (10:26 am)
Replying to: mjkiefer (Jan 22, 2009 3:54 pm) I just did this on my daughter's car last week and and it was astonishingly simple. I'm reconstructing this from memory: from nside the car there is a triangular plastic plate that you have to work off -- this will reveal a piece of foam insulation. Remove and save the insulation. Then you will see two 10mm nuts (there is a third protruding from the door frame which is not concealed behind the plastic cover) when you have removed these three 10mm nuts the mirror assembly pulls out from outside the car. Unclip the wiring harness and you can work on the mirror assembly on a bench.   If I recall, there is more foam insulation that you now have to remove. Then you will need a torx wrench -- t15 or t20, I can't recall which-- to remove the several torx screws that secure the power assembly to the mirror housing. Then reinstall   That is essentially all there is to it -- I had a damaged mirror exterior but working power element, so I had to remove my power mirror, disassembled it to remove the power component and re-install the power component in a used manual mirror housing (the housings are the same). Entire job took about 40 minutes.

Messages Page 1 of 1 All Messages Displayed

Go To Msg # Search This Discussion

You are here: Forums Sedans Saturn ION Power Window Motor