Last post on Jan 24, 2010 at 5:46 PM
You are in the Subaru Legacy & Outback
What is this discussion about?
Subaru Legacy, Subaru Outback, Engine, Wagon
#9 of 11 Re: 2004 Legacy spark plugs [bjonell]
Jan 21, 2010 (1:16 pm)
I am not sure how that generation is arranged as compared to the prior one, but that is exactly what I did - remove the battery and reservoir.
The first time I replaced them, the boots were a royal PITA. I ended up tearing one before it finally let loose. After that, I just planned on replacing the wires along with the plugs, though they were easier to remove on subsequent tries.
#10 of 11 Re: 2004 Legacy spark plugs [xwesx]
Jan 21, 2010 (1:25 pm)
Apply some di-electric grease before you reinstall them.
#11 of 11 Plugs are now in!
Jan 24, 2010 (5:46 pm)
It took about 3 hours. I took out the battery and washer reservoir and the fron plug was right there. After much pulling and tugging- it finally popped off and I got the plug out and put the new one in. I thought the back one was going to take me all day- no room! I picked up my flat iron crow bar and carefully put the long end just behind of the boot head. With my other hand supporting the other side, I gave it the pressure and "POP" it came right off! Fitting the 3 adapters and the plug extractor into the plug hole, I was able to get the last one out. If I had discovered that trick, I would have started that on the first plug and had not nearly the aggravation. Thanks for all the recommendations and help. Until I see you again in 35000 miles....