Ask the Car People.SM


Dodge Dakota Wheel Bearings

22 messages,  Last post on Jul 07, 2011 at 3:10 PM

You are in the Dodge Dakota-2010 and older Forum.

What is this discussion about? Dodge Dakota, Truck

Messages Page 3 of 3

#20 of 22 97 Dakota clutch replacement by whlitening97

Jul 07, 2010 (10:09 am)

Trying to replace the slave cylinder in a 1997 Dakota. Seems they did an upgrade and the reservoir/hose will not attach to the new slave cylinder. Local auto parts stores don't carry the reservoir/hose. Anyone know where to get a new one, or do I have to go to a junk yard and get one from a newer truck? Or is there a different way to attach the old reservoir?

#21 of 22 Tire of this by baggett

Nov 02, 2010 (10:41 am)

I have a 03 Dakota Quadcab. It has approximately 163,000 miles. I bought this truck used and have had nothing but troubleout of the frontend. I have replace the upper and lower ball joints as well as the shocks and pads and turned the Rotors. there is the history. I have replace the bearing hub on both sides multiple times 6 on passanger side and 5 on the drivers. I have checked the spindles for wear and check the spindle to race clearance of none. What is going on anyone had this issue. even though the hubs are warranty this is still pi** me off just because I can't find what is wrong and 2 I am tired of working on the same issue.
 
Thanks for any help

#22 of 22 Re: 06 dakota [dustyk] by carverman

Jul 07, 2011 (3:10 pm)

Replying to: dustyk (Mar 21, 2010 3:37 pm)
I've had to replace both of my front wheel bearing hubs. The drivers side failed
around 50K miles, the passenger just recently around 60K miles. I got a used
hub for the drivers side and bought a new timken hub as spare, which is now
being used on the passenger side. When the first hub bearing failed, I went]
to Timken and got the actual bearing, but there was no way I could get the
old one out, so I scrapped the hub. On the recent failure, I went to a machine
shop and they pressed the old one out and the new bearing in. Now that is
my spare. Years ago, you could repack the front bearings, now everything is
throwaway at high cost too. The lower ball joints are going as well, even
though I grease them myself with an grease needle by injecting some grease
into the rubber boot..but this is crap. Chrysler/dodge could have made them
with zerk grease nipples. I've just bought two MOOG balljoints that have the
grease fittings. This is nothing but a plot to make money off the owners by
Chrysler dealerships! I will never use them for any repairs!

Messages Page 3 of 3

To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement