Ask the Car People.SM


Ford Expedition not blowing heat and clicking noise

17 messages,  Last post on Dec 12, 2012 at 7:47 PM

You are in the Ford Expedition Forum.

What is this discussion about? Ford Expedition, Heating / Cooling, SUV

Messages Page 2 of 2

#11 of 17 Re: [nerdy1] by alwaysfords2

Nov 28, 2009 (3:19 pm)

Replying to: nerdy1 (Nov 28, 2009 7:00 am)
There are two of those - one controls floor to ceiling mix, and one controls hot cold mix. The floor to ceiling one is the one on top, the hot cold one is the one that is down lower. Same size part, often times it is a differnet part number for the second one becuase the axles are slightly different. It is lower and forward of the first. I have read that some people have done it with the trim in place through the change tray and cup holders, others have opted to take all the trim off from the hatch opening forward.

#12 of 17 Re: [alwaysfords2] by nerdy1

Nov 28, 2009 (4:45 pm)

Replying to: alwaysfords2 (Nov 28, 2009 3:19 pm)
I wanted to give you a big THANKS. It was the 2nd one down lower. Replaced the top and still had noise. Pulled off cover to see the 2nd one and when my son unplugged it the noise stopped. You are also right about a different axle on both of them. So my total was 46.35 to fix and not the 501.00 plus labor at Ford.
I really can't say THANKS enough. You are wonderful.
Nedra

#13 of 17 Nedra by alwaysfords2

Nov 30, 2009 (6:53 am)

Glad to save someone a few bucks, someone saved me the money 2 years ago, so I was able to pass it along.

#14 of 17 heater just clicking by gparra

Dec 04, 2009 (8:31 am)

2003 ford explorer. air conditioner works great but when i switch over to heater it just makes a clicking noise and blows air.?

#15 of 17 Exhaust pops by nerdy1

Feb 01, 2010 (1:33 pm)

HI again
I am hoping someone can help me figure out what sounds like a loud pop in the exhaust when you start the expedition and let it warm up. Sounds like expansion and contraction pops?????
It is towards the rear of the car.
alwaysford2 helped me so much when the heater in the rear stopped. I am hoping someone can help me with this annoying noise.
Thanks

#16 of 17 2010 Expedtion passenger heat doesn't work by cmp48

Dec 12, 2012 (5:04 pm)

The passenger heater blows but not hot. The rear works fine on the passenger
 
side. I know you have had threads about this before but I can't find the
 
location of the blend door and what I have to do to replace it. From what I
 
 have read this is probably my problem. Thanks for your input.

#17 of 17 Re: 2010 Expedtion passenger heat doesn't work [cmp48] by alwaysfords2

Dec 12, 2012 (7:47 pm)

Replying to: cmp48 (Dec 12, 2012 5:04 pm)
The blend door is behind the dash. To fix it you need to remove the dash or use something like the Heater Treater that goes in through the back of the glove box

Messages Page 2 of 2

To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement