Last post on Aug 03, 2010 at 10:42 AM
You are in the Jeep Cherokee and Jeep Grand Cherokee
What is this discussion about?
Jeep Grand Cherokee, Jeep Grand Cherokee SRT-8, SUV
#9 of 25 Re: 1998 Grand Cherokee Electrical (dash) problem [jeepjim]
Sep 23, 2008 (11:47 am)
This happened to me too. I have a 1999 Grand Cherokee. All I did was get a new battery and it didn't happen again. I have something else happening now though. Every now and then when I start me car and start driving the alarm goes off while I'm driving and I can't turn it off I just have to wait until it has beeped for the aloted time. Any ideas anyone? The jeep garage couldn't find anything wrong.
#10 of 25 04 Grand Cherokee limited pwr seat rear lift motor
Sep 24, 2008 (4:02 am)
Hi All !....This is my second post about this issue. I need a motor for my power seat. When I try to purchase it from anywhere (dealer, junk yards etc.) I must buy the entire track. When I search e-bay and other areas most other motors are sold seperately. It seems that only mopar is sold as a unit. I was wondering if anyone knows who makes these motors. Another question is when the dealer changes the entire track with the motors attached, what is done with them? Do I have to start dumpster diving at my local jeep dealer or ?
I would appreciate any information I could get. Thanks!
#11 of 25 Re: 04 Grand Cherokee limited pwr seat rear lift motor [topat46]
Sep 24, 2008 (12:34 pm)
i tryed to change my motor and after close looking figered that a junk yard replacement was in order os paid 120.00 for one all ok now
#12 of 25 Re: 04 Grand Cherokee limited pwr seat rear lift motor [tuggajb]
Sep 24, 2008 (1:37 pm)
Did you end up changing the entire track of the motor itself.........
#13 of 25 Re: 04 Grand Cherokee limited pwr seat rear lift motor [topat46]
Sep 24, 2008 (2:25 pm)
replaced the hole track assembly as a unit
wasent to hard just remove 4 bolts holding to floor take seat with track out tip over remove old track replace in reverse order
prob have to get track from same year and mod from junk yard
#14 of 25 Can anyone help me?
Sep 27, 2008 (10:42 am)
I just recently baught a 2000 grand cherokee so i dont know alot about them....If i make a sharp turn it vibrates, does anyone know what might be wrong with it? Any comments would be would greatly appreciated. Thanks
#15 of 25 Jeep Braking Problem
Oct 06, 2008 (8:32 am)
I have a 99 Jeep Gr.Cherokee Laredo that i recently replaced all rotors and pads on and now when i go to apply the brakes i get a rather loud clanking noise when stopping.Please help!
#16 of 25 1996 Grand Cherokee limited Heater problem
Dec 20, 2008 (1:49 pm)
Haven had heat in2 yrs,no heat,Air compressor clutch wouldnt inguage,blower motor went out,Put resistor in beside blower motor got blower working.still no air,ran double wire 1 to battery 1 to clutch through fire wall to dash installed on off switch that gave me manuel air ,still have no heat .can feel heat in the heat air channel under dash but cant get it out into the car.
#17 of 25 Re: Jeep Braking Problem [matt73]
Dec 20, 2008 (3:17 pm)
you do the replacement?
if you did is noise coming from front or rear?
if from front pad is not seated right
from rear could be emergancy brake shoes hold down spring broken or fallen off shoes.
#18 of 25 new to me, jp laredo grand 1997 v8
Jan 11, 2009 (10:29 am)
just bought my second jeep, love them. second day, belt broke, caused heat pump, fan, guard, radiator,to be replaced. Now- there is a grinding sound coming from back end. looked under and find some leakage from middle axle seal. could this be bad, also when you turn off the engine, can hear liquid running back into rear axle? ugh