engine swap on a GM

Last post on Sep 04, 2008 at 5:23 PM

You are in the Ford Crown Victoria/Mercury Grand Marquis Forum. Your Hosts are pat & karens

What is this discussion about? Ford Crown Victoria, Mercury Grand Marquis, Sedan

Outline

Messages Page 1 of 1: All Messages Displayed

#1 of 1 engine swap on a GM by shanef Sep 04, 2008 (5:23 pm)
I have an engine out of a mustang GT that I am putting in a 88 GM. I have done a mass air conversion and am using a mustang computer. my question is the edelbrock intake. It is on the driver side instead of the mustang location on the passenger side which is not an issue with the intake but the throttle cable bracket is located forward instead of to the rear and the throttle blade has to be pushed instead of pulled, is there anyone who can tell me what I need to do to fix this? I thought about trying to take the bottom of the throttle body apart to spin it around.

#1 of 1: engine swap on a GM by shanef; Sep 04, 2008 (5:23 pm)

I have an engine out of a mustang GT that I am putting in a 88 GM. I have done a mass air conversion and am using a mustang computer. my question is the edelbrock intake. It is on the driver side instead of the mustang location on the passenger side which is not an issue with the intake but the throttle cable bracket is located forward instead of to the rear and the throttle blade has to be pushed instead of pulled, is there anyone who can tell me what I need to do to fix this? I thought about trying to take the bottom of the throttle body apart to spin it around.