You are here: Forums Pickups Mazda B-Series Mazda B-Series Starting problems

Mazda B-Series Starting problems

16 messages,  Last post on Nov 23, 2009 at 1:37 PM

You are in the Mazda B-Series Forum. Your Host is kcram

What is this discussion about? Mazda B-Series Pickup, Mazda B-Series Truck, Truck

Messages Page 3 of 3 1 2 3 Prev Next Last

Go To Msg # Search This Discussion

#12 of 16 Re: wont start [driftwood2] by jrab2600i Apr 07, 2009 (8:01 am)
Replying to: driftwood2 (Mar 24, 2009 3:27 pm) I have a 1990 B-2600i p/u and shut down while driving this March. Electrical still worked but no acceleration (fuel flow)...come to find out through diagnosis testing that it was the ECM (computer chip in firewall) was bad. Fortunately was replace and back on road but unfortunately part is expensive...part and labor ($1,100.00). If truck is worth something to you it's worth the amount. My truck is almost in mint condition, I take care of it and I use it for loading and off road job site purposes. Hope this helps.
#13 of 16 94 Mazda 2300 starter by twotruck May 30, 2009 (6:35 pm)
Tried to take starter off. Removed 3 bolts but would not come off. Is there a bolt on the top that I can not see?   The new starter has only 3 bolt holes.
#14 of 16 Re: Another starting problem [alnotatwork] by lmoreno3 Jun 16, 2009 (6:31 pm)
Replying to: alnotatwork (Oct 13, 2008 5:13 pm) I was having the same problems with my '90 Mazda B2200. I found out that the problem was with the ignition key cylinder harness. I removed the steering wheel shroud then pulled and pushed on the ignition harness with my left hand, while turning the key with my right. The truck started right up. I did this for several weeks, until I noticed that the only bolt that holds the harness into the key cylinder, was a little too long. Got ahold of another one just a tad shorter and replaced the bolt. Truck now starts everytime I turn the key. Replacement harness costs about $100.00. The bolt only cost me 5 cents. Good luck and hope this helps.
#15 of 16 no spark by bumbed Jul 19, 2009 (12:15 pm)
replaced coil and ign. module, but still nothing out of ign. coil. also new rotor cap , wires and rotor button. anybody got an ideas?
#16 of 16 wont start in cold weather by kew_bugg Nov 23, 2009 (1:37 pm)
done posted this i thought but cant find it now,,, 1991 b2600 cranks easy in weather temps above 70 degress ,,wont start without either if temp is lower

Messages Page 3 of 3 1 2 3 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Pickups Mazda B-Series Mazda B-Series Starting problems