You are here: Forums SUVs Toyota 4Runner Snapped parking brake cable

Snapped parking brake cable

4 messages,  Last post on Jul 21, 2009 at 10:00 PM

You are in the Toyota 4Runner Forum. Your Hosts are steve_ & tidester

What is this discussion about? Toyota 4Runner, Brakes, SUV

Messages Page 1 of 1 All Messages Displayed

Go To Msg # Search This Discussion

#1 of 4 Snapped parking brake cable by tom_osen Aug 06, 2008 (6:37 pm)
I have a snapped parking brake cable and I need help. I have removed the old one (the front section) and replaced it with a new one. My problem is under the dash. The snapped cable is in the pull lever just below the pin that holds it inside the trough of the pull lever. I cannot remove the old pin and the small section of cable. The cable seems to have snapped above the pulley (above where it come up through the floor) in the area where the cable bends. I have tried removing the electronic signal switch, removed the one bolt holding the bracket to the floor, and removed the lower portion of the dash panel (under the steering column) to be able to remove one of the bolts attaching the pull lever bracket to the dash. Help!!...I cannot attach the new cable until i figure out how to remove the remaining portion of the old cable. Can anyone help? Replies to this message: kens4 (Sep 07, 2008 8:56 am)
#2 of 4 Re: Snapped parking brake cable [tom_osen] by kens4 Sep 07, 2008 (8:56 am)
Replying to: tom_osen (Aug 06, 2008 6:37 pm) You must remove the brake switch at the end of the tube ,also you have the dash panel off ,then at the top of the tube where the parking brake rod handle is there are 2 little "arms' sticking up.The first one closest to the dash must be pushed towards the firewall then you can push the parking rod all the way in.handle must be pushed all the way in first, and then you will be able to remove the crimped on barrel end of the cable.the rod will stick out just enough for you to remove it. pully must be removed also,those arms are the 'rachets'you hear when you pull the parking brake,the first one keeps the arm locked in place when you pull the arm out 'closest to the firewall ,second one stops the brake tube from going too far in and damaging your brake light switch.you do not need to remove any mounting bolts.
#3 of 4 SRS Light by puravidacr Jul 21, 2009 (12:47 pm)
I have a 2004 Runner with 149,000 km (diesel) - the SRS light comes on then goes off for a while then back on. 1. Can I replace this myself? 2. If so where is the sensor located? 3. I also understand that the belt replacement light should come on at 150 km as well - same questions as above Replies to this message: tidester (Jul 21, 2009 10:00 pm)
#4 of 4 Re: SRS Light [puravidacr] by tidester HOST Jul 21, 2009 (10:00 pm)
Replying to: puravidacr (Jul 21, 2009 12:47 pm) Give Toyota 4Runner Maintenance and Repair a try.   tidester, host SUVs and Smart Shopper

Messages Page 1 of 1 All Messages Displayed

Go To Msg # Search This Discussion

You are here: Forums SUVs Toyota 4Runner Snapped parking brake cable