Last post on Oct 01, 2013 at 8:58 AM
You are in the Mazda CX-7
What is this discussion about?
Mazda CX-7, SUV
#59 of 68 Re: Vibration\Problems that will not go away!!! [soldknow1]
Aug 12, 2010 (8:48 am)
I purchased a 2010 Cx 7 (non Turbo), I replaced factory 17" wheels/tires, with OEM 18" spec tires, and wheels. I have had numerous balancing,tire rotations, still has vibration. I have 5K miles on the vechile. Dealership check alignment, stated that all is within spec, car continues to vibrate (60, and 80mph), I don't know what to do, can anyone please assit?
#60 of 68 Re: Mazda CX-7 noises [zewie1]
Jan 23, 2011 (2:32 pm)
Sound from Variable Valve Timming this VVT works base on oil pressure, very common on Cx7
#62 of 68 Re: 2008 CX-7 AWD Vibration [maavalous]
Jul 18, 2011 (11:45 am)
I had the same or typically that same problem. Mazda had to replace the drive shaft that goes from the transmission to the rear drive.
Before they did that they did same repairs they did to yours.
#64 of 68 Mazda CX-7 Wheel bearing/hub = vibration
Dec 23, 2012 (1:53 pm)
Been getting an increasing vibration noise from the transmission area of my 2007 CX-7 GT AWD with 69K. Increases under load, but diminishes when turning right. Not affected by braking or placing vehicle in neutral. Mechanic took a quick ride and then put it on the lift and showed me the laterial movement (side to side) in the left rear wheel. Looked like the lug nuts were loose, but he said the left rear wheel bearing is no good and it a requires a full hub assembly replacement. Then he adds the right rear is worn also, not as bad, and suggests both be replaced for safety. been checking around and this seems to be a common Mazda problem. Anyone else?
#65 of 68 Re: Mazda CX-7 Wheel bearing/hub = vibration [taz6]
Feb 16, 2013 (10:29 pm)
changed wheel bearings at 75,000
#68 of 68 Getting same noise
Oct 01, 2013 (8:58 am)
I also have CX7 2007 and getting same underside noise loud whistle an now grinding sounds. Hope not expensive!!!! Just put new tires and that is when all started. Can it be the mechanics not properly trained???