Forums
>Wagons >Chrysler Pacifica >Chrysler Pacifica Maintenance & Repair >Chrysler Pacifica Engine Questions and Problems
You have saved this page | See all saved pages
Chrysler Pacifica Engine Questions and Problems
29 messages, Last post on Apr 15, 2013 at 9:17 AM
You are in the Chrysler Pacifica Maintenance & Repair Forum.- Your Host is kcram
What is this discussion about? Chrysler Pacifica, Engine
#9 of 29 Re: Engine Mounts [Piebu] by nehemi426
Feb 06, 2009 (10:27 pm)
Replying to: Piebu (Dec 08, 2008 3:03 pm)
is a 3.8 v6 or a 3.5, the have 2 main mounts (front an back lower ) and other in the top passenger side under the air cleaner box...
#10 of 29 2007 pacifica transmission problem!!!! by nehemi426
Feb 06, 2009 (10:45 pm)
many other problems with this year ,4.0 six speed automatic, 28000 miles my transmission broke today, before shift hard from park to drive, drive from reverse real bad,down shift on the route jump so bad, feel like the car broke in pieces, but the dealer say that was normal or maybe a problem with the cpm (need flash), after check all the problems still the same, today the transmission give up..I buy many pacifica's before (love) but the new model is real bad, never buy other again,I'm selling my now or burn this suv........#11 of 29 Re: Engine Air Filter Replacement [jimmysly] by ajglebc
Feb 08, 2009 (5:58 pm)
Replying to: jimmysly (Jun 01, 2008 7:30 pm)
These instructions for replacing the AIR FILTER were right on the money!
#12 of 29 engine rpm's clipped at 3,000 by nafga
Apr 21, 2009 (5:53 am)
During an oil change I put in 4 quarts,start engine to fill oil filter,and after a few seconds I will rev the engine a few times to warm the oil.I then shut off car and finish filling crankcase.I have used this procedure for years.This time the engine seemed to clip the rpm's at 3000.The air conditioner was on during this,and it didn't dawn on me at the time to shut it off.When oil change was finished the car went up and down the road with no rpm clipping,and I even forced the engine at or near 4000 rpm's.Was the clipping of the rpm's in park some sort of electronic safety to protect the air conditioner compressor?#14 of 29 Engine Harness by texan9
Jul 13, 2009 (8:07 pm)
How much should it cost to replace the engine harness? I was quoted 2700. Is it necessary to replace the entire engine harness? I am leery when driving for it has stopped on me six times since Dec.08. PCM changed in April. Now engine harness. Help. Thank you.#16 of 29 How hard to replace EGR in 05 Pacifica by sbpho
Apr 08, 2010 (5:53 am)
05 Limited, 99k miles. Check engine light says failing egr valve. Of course light comes on Friday, Saturday the state sends me the notice that it's time for emissions testing. Is it a pain to replace this thing that's best left to professionals, or is this a simple job for an amateur?#17 of 29 HELP! by kwtv
May 24, 2010 (11:51 pm)
I have a 2004 Pacifica 3.5 with 122k miles on it. Last night on my way to work under power
approx 70mpg with air conditioning running suddenly heard a POP saw sparks fly from under hood. Lost most power eng lite came on. I was able to turn around and limp it home. RPMs were very erratic made me think tranny, then battery lite came on. shifted back and forth up and down and at times shifted hard. I checked belt when home and it was intact. Any ideas????
#18 of 29 Re: Chrysler Pacifica Engine Questions/Problems [caliberchic] by chillnh3
Feb 04, 2011 (5:02 pm)
Replying to: caliberchic (Jul 06, 2008 5:44 am)
My engine has no power. I have three codes showing, P1080, P0080, and P0038. The 0080 is the exhaust valve control ( solenoid circuit High). The P0038 is Heated oxygen sensor ( bank 1 sensor 2 ). The last one is a mystery. P1080. can any of this cause no power at all? can't get above 20 mph.
To POST a message, please
Sign In.
Advertisement
Most Popular in Forums
Search Forums
Enter Keyword(s):
Learn More, Do More
Edmunds Community
Advertisement