11 messages,
Last post on Jul 30, 2012 at 2:02 PM
You are in the
Ford Crown Victoria/Mercury Grand Marquis Forum.
What is this discussion about?
Ford Crown Victoria, Mercury Grand Marquis, Sedan
#6 of 11 Not the control head
by snorkelbobby
Jul 26, 2010 (12:39 pm)
It is not likely the control head that is the root cause. It is likely the vacuum harness attached to the back of the control head is loose and needs tie straps to keep it tight to the control head so you don't get a vacuum leak. Vacuum leaks result in system diverting to defrost mode by law.
#7 of 11 2000 MGM Wiper Blade Problem
by drtripower
Dec 12, 2010 (2:41 pm)
My 2000 MGM has a problem where the wiper arms will lift away from the windshield the faster I go leaving water on the windshield. As I slow down the wipers will make contact cleaning the water away from the windshield. I replaced the arms, but it still does the same thing.
Any ideas?
#8 of 11 Re: 2000 MGM Wiper Blade Problem [drtripower]
by euphonium
Dec 13, 2010 (11:05 am)
Try attaching a 4 oz lead fishing weight to the middle of each arm. Duct tape may work or tie the lead weight with fishing line. This is not recommended as a fix, but to determine if or how badly you need new arms that are stronger such as found on the Lincoln Town Car.
#9 of 11 Re: 2007 Grand Marquis AC through Defroster [conroejg]
by shadetree9
Apr 04, 2011 (7:04 pm)
I did this thing called a cold boot on mine with the same problem. It worked. You turn off the ignition , unplug the two wiring harnesses on the module for one minute then plug them back in and turn on the ignition, press any button but the off and wait for it to reinitialize and calibrate about 30 minutes. It will not appear that anything is happening but start the car and try it now. I found it on a repair database at the library.
Georgie
Apr 08, 2011 (10:40 am)
i have been working on ac on 99 gm and w/ vaccum lines off i let the vaccum pulled go and now i have hooked all back up and nothing no fan ,defrost, floor, etc... help
#11 of 11 Re: Not the control head [snorkelbobby]
by toney12
Jul 30, 2012 (2:02 pm)
snorkelbobby
you had a fix for a grand marquis air blown out the defrost when the ac unit is running. IT was dated jul 26,2010, do you still have the picture for this fix? If you do could email me a copy of the repaired vacuum harness job. I posted your fix below. my email is toneyjordan98
yahoo.com
Thanks
71 of 172 How to fix this problem for $2 by snorkelbobby
Jul 26, 2010 (12:07 pm)
I just finished fixing a 2003 Grand Marquis for air blowing out the defrost only. This is the goverment mandated failure mode.
The problem is that the vacuum harness is leaking vacuum where it connects to the back of the conrol head. The vacuum harness connection ports relax after several years. You can replace the vacuum harness (F5VY-19C827-A) $20, or just clamp it tight with 2 ten inch tie straps from the Lowes or Home Depot.
Pull the trim covering the control head straight out. remove the control head (4 screws). Remove 2 torx screws holding the bottom part of control head in place. Feed a tie strap around this part so it clamps the vacuum harness to the control head. I put one tie strap on either side of the black vacuum supply hose in the center of the harness. Operate the controls to be sure it is fixed.
If you wish, you can disconnect the vacuum harness under the dash for easier working room. It just pulls out.
I can post a picture if needed.