Sign In Join 



Ford Bronco electrical problems

16 messages,  Last post on Feb 19, 2009 at 9:40 AM

You are in the Ford Bronco Forum. Your Hosts are steve_ & tidester

What is this discussion about? Ford Bronco, SUV


Messages Page 2 of 2
1
2
Prev
Next
Last
Go To Msg #
Search This Discussion

#7 of 16
JUST WON'T START by 82ncmarine
Nov 26, 2008 (11:10 am)
Reply
the other night i was leaving a club, jumped in my 1992 bronco eddie bauer and turn the key when all i got was the engine turning over. the next day i tested the wiring from the fuel pump and there was no power to the pump except for the gas gauge wire. i also noticed that the ignition control module mounted on the firewall in front of the driverside is missing one of the two screws. could this be the issue of it not firing up?
#8 of 16
94 bronco brake and hazard light problems by tjgsmith
Dec 02, 2008 (3:51 am)
Reply
I have a 94 basic bronco. The brake lights stopped working and now the hazard lights too. Also the blinkers but I put a new fuse in a fixed the blinker. I also put in a new fuse for the brake/hazard lights but it didn't do anything.
Any ideas? I am a novice:)
 
I also need new screws to put the top back on. Where can I buy them? Thanks Tonya
#9 of 16
Re: 94 bronco brake and hazard light problems [tjgsmith] by cr1985
Dec 16, 2008 (10:46 am)
Reply

Replying to: tjgsmith (Dec 02, 2008 3:51 am)

i had the same problem this summer, the fuse would short out each time i put the truck into park and then back into gear. there is a short in the steering column. it is near the hazard switch.
#10 of 16
87 ford bronco fullsize 4x4 electrical by cool78259
Jan 03, 2009 (5:38 pm)
Reply
I have an 87 ford bronco 5.0 engine.I have replaced ignition, starter and solinoid, I have already gone thru two solinoids. I have measured the voltage on the wire from the ignition going to the s on the solinoid. it reads the correct voltage.if the starter is attached to the solinoid and i bump the ignition the solinoid contacts get stuck, the starter will continue to run. even after the s wire is pulled off.if i have the wire going to the starter disconnected, turn the ignition to on and take the wire going to the starter and bump it on the + battery the truck starts up easily. will listen to any solutions. than you! p.s. battery is fully charged.
#11 of 16
91 bronco 351W wiring harnesses by bronco79
Jan 17, 2009 (10:44 pm)
Reply
Hi gang, would anybody have or know where I might be able to get the main engine harness and the main brain wiring harness for my bronco, I have been all over the internet, no luck, thanks.
#13 of 16
84 Bronco II electrical problems by AlsBroncoII
Jan 30, 2009 (7:32 am)
Reply
My problem is it kills my battery in 2 days when i hook up my battery i hear the vacume solenoids clicking on the right fender well and there is a relay on the kick panel by the puter and also clicking there is a solenoid on the back of the carb that is clicking what is the possibility a bad ignition switch any info would be appreciated please
#14 of 16
Re: 91 bronco 351W wiring harnesses [bronco79] by stereo_guy
Feb 09, 2009 (10:43 am)
Reply

Replying to: bronco79 (Jan 17, 2009 10:44 pm)

i have the computer and complete electrical harness for an 86 with the 302 in it. I bought the truck and put the motor in my 91. kept the interior and engine harness in perfect shape. computer is with it if that will help you. let me know.
 
jay
#15 of 16
Re: 91 bronco 351W wiring harnesses [stereo_guy] by bronco79
Feb 09, 2009 (7:56 pm)
Reply

Replying to: stereo_guy (Feb 09, 2009 10:43 am)

Hello Jay, thanks for the offer, but I got it all sorted out, I managed to find the harnesses I needed right here in my home town( got lucky) I was checking out the wreckers and I stopped by one that deals only in fords, and they were unloading a 91 bronco off a tow truck when I got there. So, thanks again, Derek.
#16 of 16
1982 5.8 manual 4x4 ford bronco by rodney9
Feb 19, 2009 (9:40 am)
Reply
Ya my bronco is really weird. Sometimes it starts no problem. Sometimes it woult start at all and when i do get it started everytime i shut it off it woult start again for at least a day or so. I've bought a new battery, egnition start box and new distributer cap. I have no clue what the problem is. I just keep on spending money on stuff i dont need.

Messages Page 2 of 2
1
2
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement