I need to lower the front end on my 2006 GMC Yukon by 1 inch.

Last post on May 25, 2008 at 9:17 PM

You are in the GMC Yukon Forum. Your Hosts are steve_ & tidester

What is this discussion about? GMC Yukon, Chevrolet Tahoe, Cadillac Escalade, Suspension, Truck

Outline

Messages Page 1 of 1: All Messages Displayed

#1 of 1 I need to lower the front end on my 2006 GMC Yukon by 1 inch. by toppdogg326 May 25, 2008 (9:17 pm)
I put a set of BellTech Lowering springs on the rear of my 2006 Yukon. I want to drop the front end 1 inch to level the truck. Whats the best/easiest way to do it? Its a 2WD. The shock extenders where also put on. And yes it did drop the rear approx. 3". The kit came with new torsion keys but I really don't want to have to install them if I don't have too. The adjusting screws are about in the center so it looks like I should be able to just turn them to get enough drop. If not, I assume I will have to switch them out. How many turns on the bolt? Any idea? I know I will have to lift the truck up to get the load off the wheels. Any other suggestions? Lowered Spindles is not an option at this point. Funds are low.

#1 of 1: I need to lower the front end on my 2006 GMC Yukon by 1 inch. by toppdogg326; May 25, 2008 (9:17 pm)

I put a set of BellTech Lowering springs on the rear of my 2006 Yukon. I want to drop the front end 1 inch to level the truck. Whats the best/easiest way to do it? Its a 2WD. The shock extenders where also put on. And yes it did drop the rear approx. 3". The kit came with new torsion keys but I really don't want to have to install them if I don't have too. The adjusting screws are about in the center so it looks like I should be able to just turn them to get enough drop. If not, I assume I will have to switch them out. How many turns on the bolt? Any idea? I know I will have to lift the truck up to get the load off the wheels. Any other suggestions? Lowered Spindles is not an option at this point. Funds are low.