- #3 of 8
-
Re: Fuel Pump St Fuse Blows [bob_spencer1]
by mstout
-
Jun 21, 2008 (1:16 pm)
-
|
|
Replying to: bob_spencer1 (May 24, 2008 9:51 am)
You mention that there are two fuel pump fuses. Are both in the engine compartment fuse box?
|
- #4 of 8
-
Fuses
by bob_spencer1
-
Jun 21, 2008 (6:06 pm)
-
|
|
Both fuses are together in the fuse box on LF area of engine compartment. Bob
|
- #5 of 8
-
Re: Fuel Pump St Fuse Blows
by tryumph
-
Jul 03, 2008 (12:10 pm)
-
|
|
Replying to: bob_spencer1 (May 24, 2008 9:51 am)
a likely cause is shorted/corroded/frayed wiring under the truck just in front of the fuel tank, where the wires for the sending unit and the fuel pump are located. If you don't seen an obvious short, the easiest way to try to fix this is to wrap all exposed hot wires in the vicinity in electrical tape. You can't reach the individual wires for the fuel pump right where they go into the tank (without removing the tank, which is a PITA), but it IS possible to "thread" on some spiral-shaped plastic wire wraps, which will keep the wires from touching each other (one hopes). Or it could be a bad fuel pump, but I'd check the wiring first.
|
- #6 of 8
-
98 Pontiac Sunfire Blowing Fuel Pump Fuses
by kmarlar
-
Jan 13, 2009 (6:09 pm)
-
|
|
I have a 1998 Pontiac Sunfire that will blow the fuel when it is raining, snowing, etc. I have had the fuel pump checked and it is good. Dealer said that the fuel filter was clogged and replaced it. They said that it was the problem, but it has quit again(a rainy day). What could be causing this to happen, a frayed wire?
|
- #7 of 8
-
Re: 98 Pontiac Sunfire Blowing Fuel Pump Fuses [kmarlar]
by steve_ HOST
-
Jan 13, 2009 (7:06 pm)
-
|
|
Replying to: kmarlar (Jan 13, 2009 6:09 pm)
Try the Pontiac Sunfire Electrical Issues discussion.
|
- #8 of 8
-
Re: Fuel Pump St Fuse Blows [bob_spencer1]
by woodpusher
-
Apr 18, 2009 (3:40 pm)
-
|
|
Replying to: bob_spencer1 (May 24, 2008 9:51 am)
Well why does a fuse blow? To many amps. Think of amps like gallons of water per minute. Sometimes Amps are represented as I for intensity on schematics. The must likely cause for a blown fuse is a short to ground. A short to ground means that current bypasses the intended path and flows directly to ground. There is a wire some where on you car that is exposed. I will assume that the fuse also feeds other circuits so there is probaley some other things on your car not working find out what those are and you can began to narrow your search. If you can read a schematic you are way ahead of the game.
|