Ask the Car People.SM


Jeep Grand Cherokee Electrical Problems

708 messages,  Last post on May 20, 2013 at 5:24 PM

You are in the Jeep Cherokee and Jeep Grand Cherokee Forum.

What is this discussion about? Jeep Grand Cherokee, Electrical, SUV

Messages Page 69 of 71

#680 of 708 Re: Jeep Grand Cherokee - Instrument Panel STOPPED WORKING [jacquee] by kyle012012

Dec 25, 2012 (6:51 am)

Replying to: jacquee (Nov 19, 2012 2:30 pm)
Many of the problems you're describing happened to me. I suggest you start with unhooking your battery for about 30 minutes to reset the PCM. If that fixes the issues it's just temporary. Open your driver door and you'll see a black rubber sleeve. Pull it from the door to expose the wires inside. If I had to guess there will be 1 or more of these wires either nearly severed or completely disconnected. Sometimes you have to look carefully as I didn't see the problem at first but 8 months later there it was. I used copper sleeves and electrical tape to fix mine. Took 5 minutes. Hope this helped. Good luck

#681 of 708 fan relay code 9481? by fisherman20

Jan 03, 2013 (1:01 pm)

2007 flex fuel grand cherokee has a 9481 code that indicates a bad relay, but when I swap thr high relay with the low one, the code remains the same. Does this sound familiar?

#682 of 708 fan relay code 9481; additional information. by fisherman20

Jan 03, 2013 (2:49 pm)

This problem began as a intermittent roaring fan, like it was stuck on and sounded like I was just flooring it. Sometimes it would stop and sound normal, then it would do it again in a few days. Finally it just stays on all the time and the check engine light comes on and this is where the 9481 code comes from. An interesting twist to this problem is that when the check engine light comes on the left tail light assembly stops working, and when the check engine light goes out they work again. It sounds like a short of some type but that don't explain the constant fan.

#683 of 708 JGC "liftgate open" problem by mwolf9000

Jan 16, 2013 (3:53 pm)

The rear liftgate on my 2005 JGC closes properly but a "Liftgate Open" idiot message comes up on the dashboard info screen. And so all the interior lights stay on while I'm driving. Any solution?

#684 of 708 Re: JGC "liftgate open" problem [mwolf9000] by sorterguru1

Jan 16, 2013 (9:40 pm)

Replying to: mwolf9000 (Jan 16, 2013 3:53 pm)
The first thing I would look at is the liftgate close switch. One bad switch would cause all your problems. I have the older body stlye so I don't know where yours is, but I'm sure you could find that out. Next, given the history of wiring problems in jeeps, I would look into the wiring to the switch. Good luck.

#685 of 708 P0320 - P0340 by 00jeepgcltd

Jan 24, 2013 (2:06 pm)

I am getting these codes ( P0320 - P0340 ) when using a scanner to check the engine light. I have already ordered the new sensors seeing as they are quite inexpensive. Should I replace one at a time to see if one is causing them both? How easy are they to replace?

#686 of 708 2002 Jeep Cherokee by cooper2012

Jan 28, 2013 (7:44 am)

Here ya go . Watch cylinder head with 0331 casting . Just had to replace at 130,000 miles . Heater core blew too ! Yeah big bucks for both , big buck ! Blinkers also have a problem with the relay . Pneumatic openers for hood and rear hatch door are bad . Just a few things that are true of this vehicle . Seems the whole cooling heating system has issues from what I have read . New head gasket, new cylinder head, new heater core, new radiator , what else can go wrong ?

#687 of 708 Electric Gremlins by larrys8

Feb 06, 2013 (10:07 am)

Hello all- looking for some suggestions; we have a 2012 GC Overland, we have had it for about a year and are around 16k miles. Oddly some random electric glitches have plagued us.
 
1. The Bluetooth is horrible; connectivity to my wife’s i-phone is inconsistent. She gets in the car, if she gets or makes a call, the call always starts out on the headset and then in a minute or so switches over to the car. Once connected, the noise/sound quality is a joke. I can barely understand her when I am on the phone with her.
2. The “EZ exit” seat feature stopped working for almost two months (we checked to make sure feature was activated). Then randomly it started working again and has been fine since.
3. The radio pre sets for “memory 2” will randomly get wiped out
 
So for the above, as they were minor problems, we have not returned to the dealer. Then this week, while my wife is driving the rear glass hatch (not the lift gate) will randomly release. She then has to pull over and close it. This happened 12 times between Monday and Tuesday. We have an appointment scheduled for Friday, but my guess is that they wont be able to replicate any of these issues as they are “random”
 
Has anyone else experienced any of these issues or have any solutions?
 
Thanks!!

#688 of 708 Re: fuse problem?? [sexy_redneck] by fester78

Feb 15, 2013 (8:28 pm)

Replying to: sexy_redneck (Jan 24, 2009 4:27 pm)
my name is eric kinney i am having the same problem did u get yours fixed?is so what was it ?

Messages Page 69 of 71

To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement