- #160 of 209
-
Re: intermitent flashing lights [ceekdee]
by tidester HOST
-
Jul 05, 2009 (1:52 pm)
-
|
|
Replying to: ceekdee (Jul 05, 2009 11:29 am)
It sounds like the accessory switch for your ignition key is faulty.
tidester, host
SUVs and Smart Shopper
|
- #161 of 209
-
Re: intermitent flashing lights [tidester]
by ccrash1972
-
Jul 06, 2009 (9:38 am)
-
|
|
Replying to: tidester (Jul 05, 2009 1:52 pm)
i have a 98 Grand Cherokee with 224,836 miles 2 weeks ago the AC blower would intermediately stop blowing now it blows but the ac stopped blowing cold. i know thats not what you had wrong but this is what is happening now. driving home my instrument panel went dead. all guages, radio, blower, power windows and locks quit working etc. vehicle stayed under power. then the gauges came back to life and went out again. drove 30 miles and it came back on. What the heck is going on. I have had little to no problems. the other wierd thing is that my rear passenger window hasnt worked in 2 yrs after this episode the window now works.
|
- #162 of 209
-
Re: 2005 grand cherokee cuts off during turns [gulfgirl]
by heydeno
-
Jul 06, 2009 (9:25 pm)
-
|
|
Replying to: gulfgirl (Sep 16, 2008 5:16 pm)
My jeep started doing the same thing but not only when i would turn but when i stopped at a light. It seemed if i kept it reved up to 1000 on the rpm it didn't die. Now I am having trouble with it starting. I can't trust it I have replaced about everything on the thing except for the PCM which seems to be where it is leading
|
- #163 of 209
-
Re: 02 GRAND CHEROKEE WON'T START [kampy1]
by barryz
-
Jul 07, 2009 (11:33 am)
-
|
|
Replying to: kampy1 (Jun 26, 2009 6:55 am)
ok, today my 99 grand cherokee laredo 6cyl 4wd went to the mechanic with this identical problem, and as i thought it was the cps (crank position sensor) which fixed this problem. final cost $193, of which $61 was part, rest was labor and tax. i took to a NAPA auto repair center. Dealer wanted about $300 total. Do it yourselfers beware, this part is very hard to get to, in a extremely tight fit in an almost impossible to reach place behind engine on top of bell housing. And its not as simple as just unbolt old, bolt new, as the sensor has to be adjusted to have a certain gap between it and the marker for it inside housing, as it works by a magnetic field, which may explain why so many do it yourselfers on this site replaced cps and it didn't fix and then kept spending on other parts with no success. i got a 1 year 12k mile parts and labor warranty on this. Save the do it yourself items for simpler tasks, even the mechanics have trouble with this one with all the proper tools.
|
- #164 of 209
-
Parking Brake Indicator Light
by gaj2888
-
Jul 15, 2009 (4:38 pm)
-
|
|
This light has remained on for about two weeks now. There appears to be no problem with the emergency brake or my regular breaks? Is it possibly a bad sensor?
|
- #165 of 209
-
1996 GCL theft Alarm
by georgeg4
-
Jul 16, 2009 (4:10 pm)
-
|
|
I bought my 1996 Grand Cherokee Laredo second hand , It was running fine and now I am having problems with the alarm I disconnected the switches on all the doors and now when I start it the alarm sounds and the headlights flash for several minutes . But the vehicle runs . Is there any way to disable the alarm . I can operate with the flashing headlights but I had to disconnect the horn . Another related problem is the gauges and power windows will not operate while the ignition is in the run position they will however momentaril;y work if zI turn the key close to the start position . It is not in the switch or the column because I replaced both of them attempting to correct the problem
|
- #166 of 209
-
Re: 97 Grand Cherokee ignition seems to come on by itself [autobodywizard]
by soaringeagles
-
Jul 19, 2009 (9:09 am)
-
|
|
Replying to: autobodywizard (Dec 26, 2008 3:02 pm)
This happened to mine about the same time of year..Dec 2008. You've probably sold it by now? What I did was fit a relay into the circuit to the feed to blower motor, which only (really comes on when ignition is switched on....I even kept original spade connector in place, if someone later wants to fix the proper way, since then...cured..basic, but safe and works...
|
- #167 of 209
-
Truck wouldn't start all electrical seems to be working fine!
by court1980
-
Jul 26, 2009 (10:05 am)
-
|
I have a 2005 Jeep Grand Cherokee 3.7L truck has been running fine except the radio suddenly stopped working three weeks ago. I went to the store last night turned off my truck and when I returned 5 mins later it wouldn't start! All lights on the dash work, headlights are fine, windows work, sunroof etc. the truck just would'nt start it was silent. No clicking or problems trying to turn over, just silence almost like the key was only turned halfway. This happen once before a few weeks ago and 10 mins later it started fine. Last night I ended up having to leave my truck there after trying to start it for an hour. This morning started up fine!
Any suggestions???
Could this be electrical?
|
- #168 of 209
-
Re: Truck wouldn't start all electrical seems to be working fine! [court1980]
by tuggajb
-
Jul 26, 2009 (4:22 pm)
-
|
|
Replying to: court1980 (Jul 26, 2009 10:05 am)
fiest thing i would change is ignion switch
|
- #169 of 209
-
Re: '97 Jeep Grand Cherokee-Battery draw [trekker3]
by carolyn996
-
Aug 19, 2009 (6:51 pm)
-
|
|
Replying to: trekker3 (Mar 27, 2009 11:01 am)
Hi, I owned a 1994 Jeep Grand Cherokee for 11 yrs and am still sorry I sold it. Even worse that I replaced it with a 2005 which has big time electrical problems on the gauges,heat,blower and signals. Anyway back to your problem. My Jeep would start fine all week when I drove to work but come Monday morning if it sat all weekend the battery was dead and it would not start. Same thing happened while on vacation on Northern Mich after it sat all week. When I took it to the dealer it turned out that I had too many maps in the glove box which was causing a slow draw on the battery as the glove box light stayed on ( and I could obviously not see this with the glove box closed). I took all the maps out of the glove box and never had the problem again. Good Luck Carolyn996
|