Jeep Grand Cherokee Limited Smartkey Problems?

20 messages,  Last post on Sep 15, 2011 at 7:14 AM

You are in the Jeep Cherokee and Jeep Grand Cherokee Forum.

What is this discussion about? Jeep Grand Cherokee, Electrical, SUV

#15 of 20 Re: SKIM Module [madatjeep1] by niblick45

Apr 12, 2011 (11:16 am)

Replying to: madatjeep1 (Sep 27, 2010 12:07 pm)
I have a similar problem with a 2011 JGC. The hands free function on one key was intermittent, I took it in and they gave me a new key where the hands free didn't work at all. Now the dealer says they need to replace the WIN module. I am 100% convinced these guys are clueless. It sopunds like they are just Easter egging the problem changing parts until something works.
 
4 service trips to fix a friggen' key? My first and last Jeep.

#16 of 20 2001 Jeep Grand Cherokee by champ424

Aug 16, 2011 (10:10 am)

I have a 2001 jeep grand cherokee. I am currently having problems getting it started. It will start for 3-5 seconds and stall out. I checked the fuel rail and Im getting plenty amounts of gas. However on rare occasion it starts up, my gauges and sometimes windows and door locks dont work. Although my dash lights do. I checked for a faulty instrument cluster and a bad ground... not the problem. Oh and the security light is on! Any insight please? Thanks

#17 of 20 Re: 2001 Jeep Grand Cherokee [champ424] by carlsice

Aug 24, 2011 (8:27 am)

Replying to: champ424 (Aug 16, 2011 10:10 am)
I have the same Jeep and same problem! Please post how you resolved this and I will do the same. I am re-trying reset power now. Code reader says I have "no sentry key" and immobilizer Module" message. I have three keys and two worked. The third would unlock but only start for a few seconds. I have previously replaced lock mechanism and ignition switch. Both keys worke since June but it now sits in driveway. I hate having to tow it to dealer if I can resolve where it sits.

#18 of 20 Re: 2001 Jeep Grand Cherokee [carlsice] by carlsice

Aug 24, 2011 (9:10 am)

Replying to: carlsice (Aug 24, 2011 8:27 am)
I just went out to my wonderful reliable jeep and disconected the battery, (again) and removed the coolant resevoir tank, removed the 3 connectors to the PCM and the two above attached to the firewall. I sprayed all pins with electronic contact cleaner, and blew out everything with compressed air. Re-attached everything and turned key on I realized I had gauge readings. So I tried starting and it started right up. I don't know if it was the connector cleaning/reseat or battery disconnect. I did re-set battery last week with no help. I am probably going to send next update from side of the road somewhere.....wish me luck.

#19 of 20 hey by champ424

Aug 30, 2011 (9:28 am)

how did everything work out for you? the garage is running full diagnostics on it, but i too believe its something to do with the pcm.

#20 of 20 Re: 2001 Jeep Grand Cherokee [champ424] by mgraham515

Sep 15, 2011 (7:14 am)

Replying to: champ424 (Aug 16, 2011 10:10 am)
I had the same issues with my 2001 Jeep Grand Cherokee about 2 months ago. In the end it was the PCM.
Problem started with gauges not working. Then starting/stalling issue. No a/c, windows occasionally would not work. After researching a lot of forums and blogs I tried several things. Cleaned battery terminals. Tested several modules for a short (window, MIC etc..). I had 2 problem codes, P1686 (no SKIM bus) and P1687 (no MIC bus).
The PCM is expensive. I was quoted $700.00 for a new one, not counting labor. The PCM has to be programmed to your vehicle but, this doesn't have to be done by the dealer like they want you to think. I found a company out of FL that sells refurbished and programmed PCM's. Allcomputerresorces.com. My jeep has been running fine since I replaced it a month ago. It was very easy to replace.
To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement