You have saved this page | See all saved pages
Ford Edge Accelerator Surge?
35 messages, Last post on Apr 12, 2012 at 11:49 AM
You are in the Ford Edge Forum.What is this discussion about? Ford Edge, Accidents, SUV
#32 of 35 Re: 2011 Ford Edge transmissions [akirby] by lateralg
Mar 20, 2012 (6:57 pm)
Replying to: akirby (Mar 19, 2012 5:08 pm)
Sounds like a good deal on the Focus. How do you like the way it drives & handles? I'll probably go with the download.
Not having the Nav. is no loss. My wife & I prefer my Garmin 1490.
- akirby (Mar 20, 2012 7:56 pm)
Replies to this message:
#33 of 35 Re: 2011 Ford Edge transmissions [lateralg] by akirby
Mar 20, 2012 (7:56 pm)
Replying to: lateralg (Mar 20, 2012 6:57 pm)
I like it Gary, although I don't drive it very often. It is a little cramped for legroom but I might consider the ST version shortly. The sportiness and better fuel economy is tempting. I'm only getting 18 or less in my V6 Fusion. Then again I'd really like a F150. I guess I'm not the typical shopper!
#34 of 35 Re: 2011 Ford Edge transmissions [akirby] by kutehart
Apr 12, 2012 (11:49 am)
Replying to: akirby (Mar 17, 2012 11:06 am)
My dad and I both have '08 Edges. He put his car in for service yesterday for the very issue Babbs3 explained, engine banging into gear. It was a bad OSS sensor, according to dealer. I found this info about the part on another forum, if it helps: P0720
Insufficient input from Output Shaft Speed sensor
Detailed Description
The output shaft speed sensor inputs a signal to the PCM, based on the speed of the output shaft of the transmission. The PCM compares this signal with the signal of the VSS or TCSS and determines correct tire size and axle gear ratio.
Possible causes :-
OSS sensor circuit short to GND.
OSS sensor circuit short to PWR.
OSS sensor circuit open.
Damaged OSS sensor.
Damaged PCM.
Diagnostic Aids
Verify sensor signal output varies with vehicle speed.
Output Shaft Speed (OSS) Sensor
The output shaft speed (OSS) sensor is a magnetic pickup that provides transmission output shaft rotation speed information to the powertrain control module.
The output shaft speed (OSS) sensor is mounted externally on the top of the transmission case. The PCM uses the output shaft speed (OSS) sensor signal to help determine electronic pressure control (EPC) pressure, shift scheduling and torque converter clutch (TCC) operation.
To POST a message, please
Sign In.
Advertisement
Most Popular in Forums
Search Forums
Enter Keyword(s):
Learn More, Do More
Edmunds Community
Advertisement