Last post on Apr 16, 2008 at 7:25 AM
You are in the Isuzu Rodeo
What is this discussion about?
Isuzu Rodeo, Isuzu, Auto Repair, SUV
#1 of 4 ignition coil on my 2002 rodeo
Mar 10, 2008 (12:56 pm)
I recently changed the spark plugs on my rodeo with very little problems. That is until I attempted to remove the coil around the number 6 spark plug. After removing the two screws I removed the header and the coil stayed lodged in the cylinder. I attempted to remove it with pliers but I was concerned that I would damage the coil.
Has anyone else come across this problem? Any suggestions?
#2 of 4 Re: ignition coil on my 2002 rodeo [ebcrumpler]
Mar 13, 2008 (4:01 pm)
If your talking about the one on the drivers side at the firewall, oh yeah, I actually broke that boot because of the same problem. You could try removing the coil pack from the boot (they separate with no problem) and spray some wd-40 down or something. If you twist it a bit, it might break it free. If you damage it, or completely break it like I did, it's a NAPA part # 727-74445
#3 of 4 My 1997 isuzu rodeo
Apr 01, 2008 (1:25 pm)
2.6 4 cyl rodeo isuzu . changed ignition coil and crank sensor, and still it shuts off while driving. Any suggestions please.
#4 of 4 Re: ignition coil on my 2002 rodeo [okmech1]
Apr 16, 2008 (7:25 am)
I did not see this post earlier, but to remove the stuck boot use a little compressed air down the center hole...it will break the seal and pop it right off.