Replacing Pontiac Aztek radio and heater control switches

4 messages, Last post on Mar 15, 2008 at 6:03 AM

You are in the Pontiac Aztek Forum. Your Hosts are steve_ & tidester

What is this discussion about? Pontiac Aztek, Auto Repair, SUV

#3 of 4 Re: Replacing radio and heater control switches [dartzoey] by bmurf1 Mar 06, 2008 (6:50 pm)
Replying to: dartzoey (Feb 21, 2008 10:39 am) If you haven't started on this project you need to know that there are two (2) screws that hold the bezel on at the bottom. They are torx head screws I believe a T-15 (not sure. Before that you need to take the cover off around the shift lever. One (1) screw in the cup holder, put shifter in low and remove the cover with a twist over the lever, then the two torx screws are easy to get to.
#4 of 4 Re: Replacing radio and heater control switches [dartzoey] by jnt Mar 15, 2008 (6:03 am)
Replying to: dartzoey (Feb 21, 2008 10:39 am) If everything fails, try the following options: 1. Go to the library and check out GM repair manual for this vehicle 2. Stop by the Pontiac dealer and talk with the Service Dept. The technician may even show you the Service Manual and/or give you some pointer If I remember correctly, the trim around the HVAC and radio has to be taken out. You will probably need 7mm socket driver and Philips screwdriver for most GM vehicles jt