You are here: Forums SUVs Pontiac Aztek Replacing Pontiac Aztek radio and heater control switches

Replacing Pontiac Aztek radio and heater control switches

4 messages,  Last post on Mar 15, 2008 at 6:03 AM

You are in the Pontiac Aztek Forum. Your Hosts are steve_ & tidester

What is this discussion about? Pontiac Aztek, Auto Repair, SUV

Messages Page 1 of 1 All Messages Displayed

Go To Msg # Search This Discussion

#1 of 4 Replacing radio and heater control switches by dartzoey Feb 21, 2008 (10:39 am)
Hello. I have a 2003 aztek. I have purchased a new factory radio and CD player and also the heater control switch panel off ebay for my aztek. I was wondering if anyone can tell me how I go about getting the trim/casing off around these two things so that I can take the old ones out and put the new ones in? Looking forward to some help! Replies to this message: ray80 (Feb 21, 2008 5:53 am) bmurf1 (Mar 06, 2008 6:50 pm) jnt (Mar 15, 2008 6:03 am)
#2 of 4 Re: Replacing radio and heater control switches [dartzoey] by ray80 Feb 21, 2008 (5:53 am)
Replying to: dartzoey (Feb 21, 2008 10:39 am) Hhmm trying to recall exactly how things are set up, but I know for the HVAC cluster trim you should put the tranny lever in L and carefully pry off trim piece starting at bottom (don't break the tabs that hold it in). The HVAC cluster can be removed by taking out 2 scews. The radio may be a different story, and I don't know how thats done.
#3 of 4 Re: Replacing radio and heater control switches [dartzoey] by bmurf1 Mar 06, 2008 (6:50 pm)
Replying to: dartzoey (Feb 21, 2008 10:39 am) If you haven't started on this project you need to know that there are two (2) screws that hold the bezel on at the bottom. They are torx head screws I believe a T-15 (not sure. Before that you need to take the cover off around the shift lever. One (1) screw in the cup holder, put shifter in low and remove the cover with a twist over the lever, then the two torx screws are easy to get to.
#4 of 4 Re: Replacing radio and heater control switches [dartzoey] by jnt Mar 15, 2008 (6:03 am)
Replying to: dartzoey (Feb 21, 2008 10:39 am) If everything fails, try the following options:   1. Go to the library and check out GM repair manual for this vehicle 2. Stop by the Pontiac dealer and talk with the Service Dept. The technician may even show you the Service Manual and/or give you some pointer   If I remember correctly, the trim around the HVAC and radio has to be taken out. You will probably need 7mm socket driver and Philips screwdriver for most GM vehicles   jt

Messages Page 1 of 1 All Messages Displayed

Go To Msg # Search This Discussion

You are here: Forums SUVs Pontiac Aztek Replacing Pontiac Aztek radio and heater control switches