You are here:
Forums
SUVs
Isuzu Trooper
Isuzu Trooper 4 wheel drive display flashes check light

24 messages, Last post on Nov 06, 2009 at 6:44 AM
You are in the Isuzu Trooper Forum. Your Hosts are steve_ & tidester
|
Replying to: wesbellmore (Nov 16, 2008 5:45 pm) |
|
|
Just recently on my 2002 Trooper the TOD display flashes the red CHECK light. In my problem, as soon as the engine starts the light starts flashing. Just the red CHECK light. My "Auto 4WD" does not seem to work. The 4WD low does work properly. I checked the vacuum solenoids and they seem to be functioning properly when I test them off the vehicle. Any ideas on where to go from here? John
|
|
|
Replying to: jbcol1 (Mar 09, 2009 10:59 am)
|
|
|
Replying to: brentb1 (Mar 09, 2009 2:10 pm)
|
|
|
|
| I recently had the intake manifold values replaced on my 1999 Trooper 3.2 and now I have a problem with my display of the TOD the rear wheel display green flashes and the check light flashes red. My 4 wd drive will engage and 4L has no problems. Sometimes the transmission will slip. Help any answers? | |
|
|
|
Replying to: atfdmike (Feb 16, 2008 10:29 am) |
|
|
|
| I found the problem to my TOD system. The flashing display light in the TOD area was losing the signal to the traction system in the rear end that was assoicated with the sensors in the rear wheels. Remember to reset the computer once you have fixed the sensors problem by disconnecting the battery to have the computer reset itself. I hope this helps anyone else out there. | |
|
Replying to: jbcol1 (Mar 10, 2009 8:56 am) |
|
You are here:
Forums
SUVs
Isuzu Trooper
Isuzu Trooper 4 wheel drive display flashes check light
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2002 Isuzu Trooper



Browse by Board
Browse by Topic
Today's Chats