Chrysler Sebring Engine Problems

63 messages,  Last post on Feb 27, 2013 at 10:58 PM

You are in the Chrysler Sebring Forum.

What is this discussion about? Chrysler Sebring, Engine, Sedan

#33 of 63 Re: 2.7 Has Oil Distribution Problems [observer22] by sassygirl

Sep 18, 2009 (10:30 am)

Replying to: observer22 (Sep 28, 2008 11:43 pm)
I have a 2001 Sebring with that engine size my problem is 3 weeks ago i had an oil change and i only put the synthetic oil in my engine well 2 days later i started my car and i heard this awful noise and the engine was tapping the mechanic i took it to had it for a week i got it back on a tuesday he informed me he put oil in my car and drove it and he told me my car may have engine damage or the valves were loose and if i could stand the noise it was ok well i was on my way to my National Guard Drills on a sat morning and my engine made this noise like metal on metal and the engine froze up and stopped i have 66.632 miles on my car i will have to either buy a new engine or trade it in my car is paid off and i did not want to do this all over again.

#34 of 63 Re: 2.7 Has Oil Distribution Problems [sassygirl] by mikefm58

Sep 18, 2009 (1:39 pm)

Replying to: sassygirl (Sep 18, 2009 10:30 am)
Your post is impossible to decipher, think maybe you can write a complete sentence, maybe throw in a comma or period here and there, you know, to kind of break up your thoughts?

#35 of 63 99 Sebring JXI stalling by sebring099

Sep 24, 2009 (7:22 pm)

My 99 Sebring has started doing weird things while going down the road. My check engine light and security light are the only 2 lights that come on and then the speedometer and rpm gauges dip. It lasts for just a second and the car picks back up and does fine. Sometimes it goes for days before it does it again and then sometimes 3 or 4 times a day. It runs rough for a few minutes after it happens and then runs fine. Sometimes when i stop after a short time it just dies,but starts right back up. If anyone knows anything i would love to hear from you......

#36 of 63 1999 chrysler sebring by azzura

Oct 05, 2009 (1:49 pm)

#37 of 63 2001 Coupe by 1946larry

Oct 07, 2009 (10:31 am)

Engine temp gauge gets hot then normal then hot then normal
Steam comes from under the hood sometimes - A/C compressor, evap., radiator have been replaced. Was working fine until I had the oil changed, then again started with the hot than normal. I do not want to get stuck in rush hour traffic

#38 of 63 Re: 2001 Coupe [1946larry] by malopr

Oct 08, 2009 (6:47 am)

Replying to: 1946larry (Oct 07, 2009 10:31 am)
did you replace the thermostat

#39 of 63 Re: 2.7 L New Water Pump Now No Start [thecardoc] by chellno1

Oct 13, 2009 (8:40 pm)

Replying to: thecardoc (Sep 05, 2009 8:18 pm)
Could you tell me how you knew that you needed a water pump? Was your car running hot?

#40 of 63 Re: 2.7 L New Water Pump Now No Start [chellno1] by thecardoc

Oct 14, 2009 (4:30 pm)

Replying to: chellno1 (Oct 13, 2009 8:40 pm)
That was the easy part , it was leaking .

#41 of 63 Engine problem by mikeyboyaz

Nov 30, 2009 (5:51 pm)

I have a 2005 chrysler sebring that I bought used. It has 87000 miles on it and everything was fine up until today. I went out and started the car to warm it up. The car was running fine and then it started idling rough and died. I tried starting the car back up, but all it did was crank. The engine is the 2.4L 4cylinder DOHC. I have replaced all the fuses and relays but I am still having this problem. Has anyone else had this problem?

#42 of 63 Re: Engine problem [mikeyboyaz] by jpf

Dec 01, 2009 (7:26 pm)

Replying to: mikeyboyaz (Nov 30, 2009 5:51 pm)
Did you replace the timing belt? If it's the timing belt, hopefully no damage was done to your engine. Good luck.
To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement