78 messages,
Last post on Mar 20, 2013 at 5:05 PM
You are in the
Isuzu Rodeo Forum.
What is this discussion about?
Isuzu Rodeo, Electrical, SUV
#74 of 78 1992 Isuzu Rodeo LS V6 3.1 4x4 Trailer Light Problem-Need Help ASAP!!
by darth_venom
Sep 13, 2012 (7:03 pm)
My 1992 Rodeo's trailer wiring factory plug does not work. Car has all lights brake, tail, turn signal (except right hand) working, but when I plug new harness into trailer factory plug under bumper on passenger side I have no lights on trailer. My boat's trailer lights verified working. Is there a fuse for this plug I need to check? It seems to have no power. Any help in diagnosing this problem would be graciously appreciated. Taking boat out this weekend and would like to have trailer lights working by then.
I thank you in advance for any help you can provide.
Phoen
#75 of 78 speedometer and gas gauge area lights out
by calikoala
Nov 01, 2012 (4:05 pm)
how easy is it to remove the dashboard area to replace the lights for the speedometer and gas/oilpressure indicators (right side of dials) for a 1996 isuzu rodeo?
estimated idea of time to do the job?
got any links that show the work?
#76 of 78 Re: speedometer and gas gauge area lights out [calikoala]
by matt9851
Mar 20, 2013 (3:37 pm)
you can't i have a 1992 isuzu rodeo and the insterment cluster just has plugs on the back and the cluster is all one piece, so you have to replace it all but the panels are held in by screws its fairly easy a couple place are alil hard to get to.
#77 of 78 Re: Strange Isuzu Rodeo Problems [hondosa]
by matt9851
Mar 20, 2013 (3:40 pm)
well if you can jump start it and drive it should mean the alternator is working also if you want to test it just get it started and remove the positive from the battery if it dies bad alternator if it stays running then its good.
#78 of 78 Re: speedometer and gas gauge area lights out [matt9851]
by calikoala
Mar 20, 2013 (5:05 pm)
matt9851:
actually, in a 1996 rodeo, I ended up removing the plastic bezel that surrounds the instrument panel, a few screws to remove the instrument group, disconnect a few wiring connections and the speedometer/rpm gauges comes out of the dash.. there are two bulbs that light up the speedometer and rpm areas as well as several t1 size lights that light up each gear . the large ones are common lights and i was able to buy those. I ended up moving the t1 from the 1st gear position to the D position. I will never need 1st gear that I would have to worry about it being there or not..
so all the lights I need are working ...
yay