You are here:
Forums
Coupes & Convertibles
Mazda RX-8
Mazda RX-8 Starting and Stalling Problems

50 messages, Last post on Nov 08, 2009 at 2:45 PM
You are in the Mazda RX-8 Forum. Your Host is claires
|
Replying to: uhohboy (Dec 29, 2007 1:51 pm) |
|
|
|
| I've sold several over the years, and it seems to be that the harder they're run, the btter the rotary motor does. They are certainly very sensitive, anyone remember MG, triumph, etc?? They need to be warmed fully when run, good gas is a must, and the rotary is a high RPM motor by design, the harder I've run mine, the better they've been. And I"m with the prior post, 3000+ RPM seems to help too | |
|
Replying to: boof1 (Oct 16, 2008 11:21 am) |
|
|
Replying to: boof1 (Oct 16, 2008 11:21 am) The common element: They all bought manuals, and drive them hard and fast, the way the rotary was meant to be utilized. The best thing you can do to a rotary is redline it. The worst thing you can do is lug it. If you're spending most of your time above 4000 RPM, your 8 will thank you. Make sure you redline it a couple times a day.
|
|
|
I have just purchased a used 2004 Mazda RX-8 with 88,000 miles. I am having an issue where, while driving the car the check engine light and the TCS/DSC Indicator light will come on. When it does the the car will stall - mind you this is while driving down the freeway doing 60+. Can you help me trouble shoot this?
|
|
|
Replying to: johnrvw (Mar 08, 2009 1:32 pm) Throttle Control valve and gasket needs to be replaced. ($436 just for the parts) |
|
|
|
|
Replying to: boof1 (Oct 16, 2008 11:21 am) The same thing happen to my mazda rx-8.I have only 27,000 mile. Like when I came to a stop light the car tendes to bog and then pick up speed and then it stops.i took it the the dealership and the clean the carbon out and it will run good for awhile and start doing it again ..In a week I will take it back to the dealer and get it check out again its a never ending story.the is a problem in the motor and someting is going on with it |
|
| I tried to start my RX8 and it sounded like the solenoid was clicking but the engine did not turn, is this a common fault and is there anything i can do ? help please. | |
|
|
|
Replying to: shady7 (Jun 07, 2009 6:21 am) There is a problem with the stock starter. and dealer replace my starter with a high torque starter from mazda is your car still under warranty and does you car wont start when its cold. let me know |
|
|
Replying to: shady7 (Jun 07, 2009 6:21 am)
|
|
You are here:
Forums
Coupes & Convertibles
Mazda RX-8
Mazda RX-8 Starting and Stalling Problems
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 Mazda RX-8



Browse by Board
Browse by Topic
Today's Chats