Edmunds.com | Inside Line | Auto Observer Your Account | Help | Directory
You are here:
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
Sedans Toyota Camry Older Camry Maintenance and Repair
558 messages, Last post on Nov 20, 2009 at 11:36 AM
You are in the Toyota Camry Forum. Your Hosts are pat & karens
My 02 Camry has 59,300 miles. In past 6 wks, the heat only comes out of the top (dash) vents. No Heat from the bottom, regardless of the settings on the dial. Dealer sez the heater box assembly needs to be replaced which means the dash wud have to be removed. Estimate for parts and labor $2997!!! LOL. Has anyone had a similar problem? Any suggestions (other than live with it).
|
|
|
Replying to: TLeesaM (Dec 20, 2008 6:48 am) I don't have my service manuals available, but I would hope that they could just fix whatever the problem part is, as opposed to replacing the whole heater box assembly. Heck, you just might have a bad selector switch.
|
|
|
|
|
Replying to: kiawah (Dec 21, 2008 7:20 am) There nothing wrong with the heater box. Its just a box. The heater switch is not sending a signal to the door that direct heat out of the box. Take your radio out and you can follow the cable to the heater box from the heater switch and the temp switch. Some cars you can see it from under the glove box. Remove the glove box too. Its just a couple screws. If you pinch the glove box sides to the center it drops down out of your way. Look on the box for any levers that move that is where the problem is.You can move them and see how it works. |
|
|
Replying to: kiawah (Apr 20, 2008 3:51 pm) the main issue was a pinced wire routed near drvr side trunk hinge was pinching and shorting to ground ( chassis) unbeleivable (forgot to let you know have a few more questions about older toyota 92- 93 does anyone know what need to be changed to put a 2.2 engine from a camry in a celica that came with a 1.8. does wiring harness need to be changed or just the computer? paul
|
|
|
Replying to: pawleep (Dec 23, 2008 6:28 am) Glad you found it. |
|
|
|
My check engine light went on I Just change my air intake valve. My car wont start up right away it sputteres and dies a few time then will stay on what is that
|
|
|
Replying to: dfiveturtles (Jan 07, 2009 12:57 pm)
|
|
|
|
|
Replying to: kiawah (Jan 07, 2009 1:07 pm)
|
|
|
Replying to: dfiveturtles (Jan 07, 2009 3:54 pm) 1.) Did you have this problem, you put this part in to try and resolve, and now nothing is different.............(therefore, the problem is NOT related to that part). OR 2.) You replaced that part (for some reason), and now you have this new problem which you didn't have before...............(therefore, the problem IS related to that part). If so, have you taken this new part out, and put the old part back in, to see if the symptoms change?
|
|
|
|
|
Replying to: kiawah (Jan 07, 2009 8:15 pm)
|
|
You are here:
Forums
Sedans Toyota Camry Older Camry Maintenance and Repair
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 Toyota Camry
Browse by Board
Browse by Topic
Today's Chats
