You are here:
Forums
SUVs
Jeep Liberty and Jeep Liberty Diesel
Jeep Liberty Power Windows

142 messages, Last post on Nov 21, 2009 at 4:59 AM
You are in the Jeep Liberty and Jeep Liberty Diesel Forum. Your Hosts are steve_ & tidester
|
|
|---|---|
|
Replying to: neovox (Sep 23, 2009 4:27 am) |
|
|
Replying to: neovox (Sep 23, 2009 4:27 am) I called the dealership and amazingly, they weren't going to charge me for the diagnosis! I took my car in to get it looked at and told the dealership to also look at the front passenger window because it was being sluggish. After a few hours, I got the call from the dealership saying that Chrysler took care of the cost on the repair. When I asked about the sluggish window, they said that they went ahead and replaced that one too! So, hang in there Liberty owners! If I can get Chrysler to replace TWO of my windows for free, then you can too! They did mention that it is a case by case basis and that some of it depends upon how "loyal" you are to the Chrysler brand. I own a Jeep and a Dodge, so that may have helped my case...
|
|
|
|
|
Replying to: kiwishae (Sep 30, 2009 8:44 pm) |
|
|
Replying to: edlankford (Aug 01, 2009 11:45 am) |
|
|
|
|
Replying to: ldillon (Nov 09, 2009 8:29 am) I agree with you, Chrysler/Jeep will never see me driving any of their products once this goes to the scrap heap. Also, if you have to replace a window, buy it and take it to safeco, they will install for $65 instead of $200 at the dealer. And the guy in the parts department told me that the replacement windows and regulators are from previous years models when they were using sturdier parts...I am starting to search junk yards. I just can't imagine that there is not someone at Jeep with a conscience who would look at all the sales of these windows and regulators and say "This ain't Right" ! And we the people bailed them out, they should go the way of the edsel. |
|
|
Replying to: edlankford (Nov 09, 2009 9:07 am) There is no doubt that the problems with these window regulators are a design issue. There are aftermarket parts availably that actually fix the problem but Chrysler refuses to admit it and at least come up with a replacement part that lasts. The sad part is that they are destroying a good product line to make a few executives and union bosses rich. Is this the result of someone unsuccessfully attempting to deisgn a safer product... A window regulator that breaks or gives way instead of cutting off someones arm?
|
|
|
|
|
Replying to: kenf3 (Nov 10, 2009 9:26 pm) It is sad that something as serious as this and as costly to the consumer as this is that the Government has not forced Jeep to at least inform the owners of the vehicles with the cheap plastic connector which VIN numbers were involved so they could remedy the problem before there is a disaster. They are totally irresponsible and it is a shame that they pretend its no problem, that all the windows fall out of a brand new vehicle. |
|
|
Replying to: edlankford (Nov 09, 2009 9:07 am) This guy at Steiger Performance has created a replacement for the plastic part that fails in the regulator, this one made from powder coated metal. He will send the part and very detailed instructions to install for $87. If yours is out of warranty like mine, and you are (or know someone) not afraid to get your hands dirty, this might work for you. I am going to order one today and I will post again after installing it. Wish me luck!
|
|
|
|
|
Replying to: kthiel (Nov 16, 2009 3:44 pm) Beachpatty |
|
You are here:
Forums
SUVs
Jeep Liberty and Jeep Liberty Diesel
Jeep Liberty Power Windows
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 Jeep Liberty



Browse by Board
Browse by Topic
Today's Chats