2006 Impala-changing air filter and cabin air filter

5 messages, Last post on Oct 29, 2007 at 8:48 PM

You are in the Chevrolet Impala Forum. Your Hosts are pat & karens

What is this discussion about? Chevrolet Impala, Sedan

Outline

Messages Page 2 of 2: 1; 2; Prev; Next; Last

#4 of 5 Re: cabin filter [steve333] by quietpro Oct 29, 2007 (2:54 pm)
Replying to: steve333 (Oct 28, 2007 8:10 pm) I haven't changed the cabin filter on mine yet but assuming it isn't much different than the setup on my last car (a Monte Carlo), it wasn't all that hard. I think the key with it was stopping the windshield wipers in the up position. I think all you need is a standard screwdriver and again, a little patience to learn the "trick" to getting the pieces to snap into place. Unfortunately, you'll only replace them once or twice once you learn how to do it. Replies to this message: steve333 (Oct 29, 2007 8:48 pm)
#5 of 5 Re: cabin filter [quietpro] by steve333 Oct 29, 2007 (8:48 pm)
Replying to: quietpro (Oct 29, 2007 2:54 pm) I think its the same as the Monte. Have to clear away some weather stripping and unplug the washer hoses then unscrew a plate from what I understand. Much easier on the cobalt, just plop down the glove box door and there it is.

#4 of 5: Re: cabin filter [steve333] by quietpro; Oct 29, 2007 (2:54 pm)

Replying to: steve333 (Oct 28, 2007 8:10 pm)

I haven't changed the cabin filter on mine yet but assuming it isn't much different than the setup on my last car (a Monte Carlo), it wasn't all that hard. I think the key with it was stopping the windshield wipers in the up position. I think all you need is a standard screwdriver and again, a little patience to learn the "trick" to getting the pieces to snap into place. Unfortunately, you'll only replace them once or twice once you learn how to do it.

steve333 (Oct 29, 2007 8:48 pm)

#5 of 5: Re: cabin filter [quietpro] by steve333; Oct 29, 2007 (8:48 pm)

Replying to: quietpro (Oct 29, 2007 2:54 pm)

I think its the same as the Monte. Have to clear away some weather stripping and unplug the washer hoses then unscrew a plate from what I understand. Much easier on the cobalt, just plop down the glove box door and there it is.