You are here: Forums SUVs Ford Bronco 1989 Ford Bronco II replacement with a 302 Ford engine

1989 Ford Bronco II replacement with a 302 Ford engine

14 messages,  Last post on Oct 09, 2009 at 10:59 PM

You are in the Ford Bronco Forum. Your Hosts are steve_ & tidester

What is this discussion about? Ford Bronco, Ford Bronco II, SUV

Messages Page 2 of 2 1 2 Prev Next Last

Go To Msg # Search This Discussion

#9 of 14 Thanks for the help by deb32 Jan 25, 2008 (8:17 am)
To all of you thanks for all the help and TFI it was and things are good again. Back to driving my bronco. Deb
#10 of 14 my 88 bronco 11 by buddy25 Mar 02, 2008 (6:18 am)
i have a 88 bronco 11 going to do a bunch of work to it engine swap 5.0 lift kit big tires so on so on i have a 84 full size bronco for motor trans axels everything i need any suggestions on were to start full saize is everything there would it be easeier to cut full size frame down to match my wheel base and put my body on it or put everything under and in my frame
#11 of 14 Code 18 by dj7 Jun 22, 2008 (6:27 am)
I keep getting a code 18. I have replaced the module and checked all the wirng . Any ideas???? I have an 88 Bronco 11 2.9 5 speed 4X4
#12 of 14 Re: 87 Ford Bronco II starting problems [deb32] by classiclo1959 Apr 21, 2009 (11:48 am)
Replying to: deb32 (Jan 21, 2008 6:40 am) Hello deb34, I have an 88 Bronco II and had the same trouble. Fortunately, a freind was a mechanic and told me about a part I did not know existed on my Bronco. Right behind and below the rotar is a small chip, like a stick o RAM memory. It fastens in with a small screw and slips out. It cost about $245 at Ford, but I was able to locate 1 at a salvage yard for $20. It takes a short, 3" screw driver to get to it. Removal of rotar is not required, but may make it easier. Once I replaced that all the problems went away. It is unfortuante that I spent all the money on the other parts!!   classiclo1959
#13 of 14 1988 Ford Bronco II Starter Problem by classiclo1959 Apr 21, 2009 (12:01 pm)
Just yesterday I started having a problem with the original starter on my 1988 Bronco II. The bendix or solenoid does not seem to kick out when it should after vehicle starts and runs on for a short time. Is this the starter itself, or the solenoid on the right fender?   classiclo1959
#14 of 14 Cab Visor by dannit Oct 09, 2009 (10:59 pm)
I'm looking for a 89" Ford Bronco II Cab Visor. I can't find one locally and I am stuck on getting one. Does anyone know where one can be found; and how I could buy one over the internet from a private seller without getting ripped off. I'm up for any suggestions? Thanks.

Messages Page 2 of 2 1 2 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums SUVs Ford Bronco 1989 Ford Bronco II replacement with a 302 Ford engine