You are here:
Forums
SUVs
Ford Bronco
1989 Ford Bronco II replacement with a 302 Ford engine

14 messages, Last post on Oct 09, 2009 at 10:59 PM
You are in the Ford Bronco Forum. Your Hosts are steve_ & tidester
|
|
|---|---|
|
Replying to: deb32 (Jan 21, 2008 6:40 am) I have an 88 Bronco II and had the same trouble. Fortunately, a freind was a mechanic and told me about a part I did not know existed on my Bronco. Right behind and below the rotar is a small chip, like a stick o RAM memory. It fastens in with a small screw and slips out. It cost about $245 at Ford, but I was able to locate 1 at a salvage yard for $20. It takes a short, 3" screw driver to get to it. Removal of rotar is not required, but may make it easier. Once I replaced that all the problems went away. It is unfortuante that I spent all the money on the other parts!! classiclo1959 |
|
|
|
|
Just yesterday I started having a problem with the original starter on my 1988 Bronco II. The bendix or solenoid does not seem to kick out when it should after vehicle starts and runs on for a short time. Is this the starter itself, or the solenoid on the right fender? classiclo1959 |
|
| I'm looking for a 89" Ford Bronco II Cab Visor. I can't find one locally and I am stuck on getting one. Does anyone know where one can be found; and how I could buy one over the internet from a private seller without getting ripped off. I'm up for any suggestions? Thanks. | |
You are here:
Forums
SUVs
Ford Bronco
1989 Ford Bronco II replacement with a 302 Ford engine
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
1996 Ford Bronco
1990 Ford Bronco II



Browse by Board
Browse by Topic
Today's Chats