Last post on Jul 26, 2010 at 5:13 PM
You are in the Ford Escape
What is this discussion about?
Ford Escape, Fuel System, Fuel System, SUV
#6 of 9 Re: 2008 Ford Escape Fuel Filter Replacement [mwtp2010]
by vg33e power
Nov 05, 2009 (12:17 pm)
They should just come off if you removed the retaining locking clips properly...try rotating the filter to break any seal or vaccumm the lines may have. Good Luck!
#7 of 9 Re: 2008 Ford Escape Fuel Filter Replacement [mwtp2010]
Nov 22, 2009 (9:53 am)
I am also having the same problem but found out some information from various web sites. First you need to relieve presure on the fuel system. One site said to open the gas cap, locate the fuel pump fuse (Escape is fuse #3 and was listed in the owners manual) and start the engine then pull out the fuse and the engine should die after a few seconds. Then you need to get a little plastic tool called an A/C & Fuel line Quick Disconnect Tool Set. ($10 at auto store) The one you need to use it the 5/16" one. Push it over the tube and then down into the connector. It is supposed to release the connector from the filter tube. Saying all that I still could not get the connector off. So if anyone has more info please post. Thanks.
#8 of 9 fuel filter problem
Mar 29, 2010 (12:02 pm)
I am having the same problem
#9 of 9 Re: 2008 Ford Escape Fuel Filter Replacement [mwtp2010]
Jul 26, 2010 (5:13 pm)
I had the same problem. The connectors have four tabs that lock over the collar o f the filter line. I used a hacksaw to nick the line on the old filter and bent it until it broke off. The fuel did spray some so watch for the mess! Then I made a sleeve from an old piece of sheet metal and slid it over the line left in the connector. I pulled the sleeve and line out together with needle nose pliers. Worked well but it was meesier than it should have been but I wasn't going to the dealer to buy some special tool.