You are here: Forums Sedans Chrysler 300M Chrysler 300M Brake Issues

Chrysler 300M Brake Issues

5 messages,  Last post on May 04, 2009 at 2:19 PM

You are in the Chrysler 300M Forum. Your Hosts are pat & karens

What is this discussion about? Chrysler 300M, Brakes, Sedan

Messages Page 1 of 1 All Messages Displayed

Go To Msg # Search This Discussion

#1 of 5 2002 300M Front Brake Issues by th300m Oct 08, 2007 (11:35 am)
I own a 2002 300M, front brake will automatically come on. I've replaced the ABS module, pump, speed sensors are ok. Turn ABS & traction control off still does it, HELP!!! Replies to this message: tayl0rd (Oct 09, 2007 4:51 am) th300m (Oct 09, 2007 5:55 am) wec02 (May 04, 2009 2:03 pm)
#2 of 5 Re: 2002 300M Front Brake Issues [th300m] by tayl0rd Oct 09, 2007 (4:51 am)
Replying to: th300m (Oct 08, 2007 11:35 am) Replace the calipers or have them overhauled. Is it both or just one side? Replies to this message: th300m (Oct 09, 2007 5:55 am)
#3 of 5 Re: 2002 300M Front Brake Issues [tayl0rd] by th300m Oct 09, 2007 (5:55 am)
Replying to: tayl0rd (Oct 09, 2007 4:51 am) It happens on both sides, I've had my Mechanic look at this and Chrysler dealer and they both said the calipers are good.
#4 of 5 Re: 2002 300M Front Brake Issues [th300m] by wec02 May 04, 2009 (2:03 pm)
Replying to: th300m (Oct 08, 2007 11:35 am) I own a 2002 300m and had the same problem.After a month of going to dealerships and garages.The problem was intermittent my brakes would engauge on the highway and the front end would start shaking.You couldnt even touch the wheels they would be burning hot.I replaced lines had a fluid power flush but still happened.I was finally able to get it to a chrysler dealer when it was happening.What they found was the master cylinder valves were hanging up.They replaced the master cylinder and has been fine since.When the prolem accurd you could put car in drive and it wouldnt move.Good luck.
#5 of 5 2002 parking brakes by wec02 May 04, 2009 (2:19 pm)
I have a 2002 300m and just replaced parking brakes.Had no problems until I tried to adjust to 6-3/4 across shoes before installing rotor.Adjusted as tight as I could 7 inches the rotor went on but brakes are dragging enough to cause heating at rotors.Any suggestions would be appreciated thanks.

Messages Page 1 of 1 All Messages Displayed

Go To Msg # Search This Discussion

You are here: Forums Sedans Chrysler 300M Chrysler 300M Brake Issues